I need to know how to get the rear door panel off a kj 06'
| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| rear door panel removal http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=1&t=13423 |
Page 1 of 1 |
| Author: | big daddy adams [ Sat Oct 14, 2006 4:26 pm ] |
| Post subject: | rear door panel removal |
| I need to know how to get the rear door panel off a kj 06'
|
|
| Author: | Skyjump136 [ Sat Oct 14, 2006 4:47 pm ] |
| Post subject: | |
As in the plastic stuff on the inside? Also are you talking about a passenger door or the rear swing gate? If its the swing gate then you just pull... |
|
| Author: | Maximum Carnage [ Sat Oct 14, 2006 6:31 pm ] |
| Post subject: | |
Show pics when done |
|
| Author: | big daddy adams [ Sun Oct 15, 2006 11:03 pm ] |
| Post subject: | |
Thanks for the answer. It is the side dr. The window quit working and something is loose in the door. Something is rattling in the side of the back part of the door. You can move the window up and down with your hands. it is off the track or something. Its under warranty its just a hasle to take it in for warranty work. |
|
| Author: | JMLoughrey [ Mon Oct 16, 2006 1:22 pm ] |
| Post subject: | |
dont know if the doors are the same in my 03kj as your 06 but i dont think it'd be too different. On the rear doors there are two screws you'll have to remove. One is behind the door handle in that little black square thing in the center, you'll need to take a pick and move the cover covering the screw. There is also a screw in the actual slot in the door that you would pull if you were pulling the door closed. Once those two screws are out you should just be able to pick a bottom corner and pull out the pop clips. When all the pop clips are off the only thing holding the panel on should be the little conector for the door handle itself and the door lock pin. Undor those and you should be golden. |
|
| Author: | CaKJFreedom [ Wed Oct 18, 2006 5:54 pm ] |
| Post subject: | |
For an 06 why don't you just take it to the dealer and let them mess with it? |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|