Rusty's 2.5" Exhaust System

Guyute1210 · **Posted:** Tue Aug 23, 2005 12:58 pm

I know this is a new product, but has anyone installed this exhaust yet? I don't like the fact that my muffler sticks out below the skids and rock rails, and I am looking for something that will tuck up above the frame a bit better. I know Jeepin' Al had a custom bent pipe, but i would rather not go that route, if there is something out there. Thanks!

WestyKJ · **Posted:** Tue Aug 23, 2005 9:45 pm

Many of us have FlowMaster mufflers. Mostly in the 40 or 50 style. They are about 1 1/2" thinner than stock and built like tanks. No need to replace the exhaust, it is excellent already.

Mike

uvalax236 · **Posted:** Wed Aug 24, 2005 12:03 am

I had cut my muffler off and had ghetto rigged it. One of the peices fell off and actually ripped all of the exhaust piping from the (I have an 02) last cat all the way back off. I had my Flowmaster 40 series put in with 2.5" inside diameter piping installed and it sounds great. All this was done for a meer $160.00 after tax.

Trodo · **Posted:** Wed Aug 24, 2005 10:32 am

I went with the new Edelbrock design. It's tucked up really tight and not only kicked out more HP and torque, but has a good growl too. I also left the pipes alone.

Guyute1210 · **Posted:** Wed Aug 24, 2005 12:03 pm

Trodo wrote:

I went with the new Edelbrock design. It's tucked up really tight and not only kicked out more HP and torque, but has a good growl too. I also left the pipes alone.

Do you have a link or part/kit numbers?

Guest · **Posted:** Wed Aug 24, 2005 1:50 pm

Guyute1210 wrote:

Trodo wrote:

I went with the new Edelbrock design. It's tucked up really tight and not only kicked out more HP and torque, but has a good growl too. I also left the pipes alone.

Do you have a link or part/kit numbers?

CLICK HERE

Rusty's 2.5" Exhaust System

Who is online