LOST JEEPS
http://www.lostjeeps.com/forum/phpBB3/

Are all fasteners on Liberty Metric?
http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=1&t=1793		 Page 1 of 1
Author:  Wasatch15 [ Sun Sep 11, 2005 9:46 am ]
Post subject:  Are all fasteners on Liberty Metric?
Just wondering if any of the tools in my off-road kit need to be SAE? :?:
Author:  corwyyn [ Sun Sep 11, 2005 10:19 am ]
Post subject: 
The only thing that comes to mind that might be SAE is litle stuff like the bolts on hose clamps or other small assembly items, but I would think even most of those would be metric. I do know when I would work on my '98 Dakota that I used metrics all the time and I haven't used an SAE wrench yet on my Jeep.
Author:  rlruss [ Sun Sep 11, 2005 10:33 am ]
Post subject: 
Funny you should ask. I replaced my brake pads on my 2003 renegade yesterday and the two bolts that hold the rear caliper on are 1/2" SAE. I thought this was weird; I have done quite a bit of wrenching on my KJ and it was the first fastener that I have fouun that is not metric or Torx.
Author:  corwyyn [ Sun Sep 11, 2005 10:41 am ]
Post subject: 
rlruss wrote:
Funny you should ask. I replaced my brake pads on my 2003 renegade yesterday and the two bolts that hold the rear caliper on are 1/2" SAE. I thought this was weird; I have done quite a bit of wrenching on my KJ and it was the first fastener that I have fouun that is not metric or Torx.

That is weird. When I would replace the brake pads on my Dakota the bolts holding the caliper assembly on took a 7mm allen wrench :? Guess it depends on the manufacturer...
Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/