| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| Mopar skid plate question http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=1&t=20942 |
Page 1 of 1 |
| Author: | chetos [ Tue May 22, 2007 10:24 am ] |
| Post subject: | Mopar skid plate question |
So I am planning my install of Mutt's Tcase Skid Row plate. Here's my question. Starting with the engine skid plate and working back: Does the rear of engine skid use the same holes as the front of tranny skid? and does the rear of the tranny use the same as the front of the tcase? I don't mind drilling and tapping but if I can save some time...yeah, I like to look at all angles. Thanks. |
|
| Author: | spoonplugger1 [ Tue May 22, 2007 11:26 am ] |
| Post subject: | |
You got it! Gett'er done. |
|
| Author: | raceinfan [ Tue May 22, 2007 4:14 pm ] |
| Post subject: | |
they should use the same holes |
|
| Author: | humptyjumped [ Tue May 22, 2007 5:28 pm ] |
| Post subject: | |
just put all the plates on yesterday (mopar). i would just jack the truck up and have a look just holding the plates up. It become really clear where you have to drill/nutzert etc. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|