Has anyone installed a 5 Point Harness in their KJ? I was wondering how it would look and also how much of a pain it is to disable the seatbelt sensor for the driver's seat? I guess depending if it's active high or active low you might be able to just ground it out.

_________________
____________________________
Jason

2003 Red Wrangler Freedom Edition

2009 Black Grand Cherokee Rocky Mountain Edition

I have thought about putting in a 4 point cause I like to be held in place and the stock belt allows me to slide around, especially in the Santa Cruz mountains where I live. I was thinking of just leaving the stock belt, cause my girl friend doesn't like 4 point harnesses, and just attach the 4 point to the 4 bolts that hold down the seat.

Stephen

_________________
04 5sp. with mods

http://www.cardomain.com/ride/798121

Yeah, that might work too. The other thing I was worried about too is that with a 5 point I know there's the danger of compressing your spine if there's no bar to bring it over but I could always have a brace welded in.

_________________
____________________________
Jason

2003 Red Wrangler Freedom Edition

2009 Black Grand Cherokee Rocky Mountain Edition

Just be sure you mount the seat belts correct. You cannot just bolt them to the existing bolts. You must run a bar along the back of the seats so it does not crush your spine in a wreck.

_________________
LOST KJ'S
Where are you going???
Current Jeep: 2004 Jeep Liberty
-Atlantic Blue
-Air Ride Rear Suspension ; OME/Rustys Lift ; Powertrax Locker ; Moog Lower Ball-Joints ; 245/70/16 Yokohama Geolander A/T-S's on MOABS ; Flowmaster 50 SUV
Lost #007082
http://www.cardomain.com/id/jeepjeepster