| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| Tow hooks http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=1&t=34817 |
Page 1 of 2 |
| Author: | jeepmedic46 [ Thu Aug 07, 2008 12:01 pm ] |
| Post subject: | Tow hooks |
Going to try and install tow hooks today, Do I need to take the plastic part off? Does it just pull off? |
|
| Author: | lionseye640 [ Thu Aug 07, 2008 12:27 pm ] |
| Post subject: | |
In case your tow hooks didn't come with installation instructions http://site.justforjeeps.com/guide/82206124.pdf |
|
| Author: | jeepmedic46 [ Thu Aug 07, 2008 12:44 pm ] |
| Post subject: | |
Thank You, Let you know how it goes |
|
| Author: | WoodysKJ [ Thu Aug 07, 2008 3:01 pm ] |
| Post subject: | |
Are they the "Option" tow hooks as pictured in the pdf link above? Or are they the factory installed ones your purchased from somebody and do not have the "M" bolts? BIG difference on the install. |
|
| Author: | jeepmedic46 [ Thu Aug 07, 2008 3:24 pm ] |
| Post subject: | |
Universal tow hooks, Would have got them from the dealer but they wanted a 140 dollars just for the front. Haven't had a chance to get to it yet. Any ideas? |
|
| Author: | jsc7002 [ Thu Aug 07, 2008 3:33 pm ] |
| Post subject: | |
what hooks did you get? do you have a pic of them? |
|
| Author: | jeepmedic46 [ Thu Aug 07, 2008 3:36 pm ] |
| Post subject: | |
just regular tow hooks, will try and get a pic. |
|
| Author: | WoodysKJ [ Thu Aug 07, 2008 4:03 pm ] |
| Post subject: | |
icefisher45 wrote: Universal tow hooks, Would have got them from the dealer but they wanted a 140 dollars just for the front. Haven't had a chance to get to it yet. Any ideas?
What are "universal" towhooks? For the KJ there are only 3 kinds. The factory installed, the option hooks for the dealer to install (PDF install sheet linked above) and the single rear hook. If you got these someplace and they listed the libby as a fit please give us info on where. My bet is, to be kind, that you got screwed and or bought the wrong hooks. If they do not have the base plate like the ones pictured in the PDF link, they will not fit. |
|
| Author: | jeepmedic46 [ Thu Aug 07, 2008 4:14 pm ] |
| Post subject: | |
Think I got screwed, these do not have a base plate. Thank you for your help. |
|
| Author: | WoodysKJ [ Thu Aug 07, 2008 4:47 pm ] |
| Post subject: | |
not to say they can't be made to fit, lots of people have tried. Look for some used ones in the for sale section. some come up for sale all the time. The find out if they were factory installed or dealer installed. |
|
| Author: | DryBones [ Thu Aug 07, 2008 5:53 pm ] |
| Post subject: | |
look for the Mopar hooks on eBay. you can find them cheaper than $140. Aww, what the heck, I did it for you. Shipping included under $100. This is where I got mine, IIRC 
http://cgi.ebay.com/ebaymotors/02-07-Jeep-Liberty-black-front-tow-hook-NEW-OEM_W0QQcmdZViewItemQQ_trkparmsZ72Q3a1075Q7c39Q3a1Q7c66Q3a2Q7c65Q3a12QQ_trksidZp3286Q2ec0Q2em14Q2el1318QQhashZitem350086600615QQitemZ350086600615 |
|
| Author: | JPaul [ Fri Aug 08, 2008 1:41 am ] |
| Post subject: | |
Sounds like you're talking about the inexpensive tow hooks rated at 10k lbs each, they have a couple holes in them for mounting, you can get them most places for aobut $10 each? If so, then you might be in for more than you bargained. I have heard of a couple people who have used these, as soon as they tried to use them they twised the frame, and I think one guy had it tear off the frame from pulling sideways. The only reason they do this is the very small contact area with the frame. the frame on the KJ isn't very thick, it's formed steel, but not like a truck frame or anyhting. You could make it work I but, it would just require getting some flat bar steel to make backing forthe hooks. It probably would work pretty well that way. Make a peice for each side of the frame (inside and outside). they would act like huge, thick washers and spread out the forces a lot better that way. 3/16" steel would probably work pretty well for that and would not be too hard to fabricate, nor cost you much more. |
|
| Author: | mrkake [ Fri Aug 08, 2008 4:20 am ] |
| Post subject: | |
I got mine on Ebay shipped for about $85. The seller is a Chrysler dealer. |
|
| Author: | jeepmedic46 [ Fri Aug 08, 2008 7:52 am ] |
| Post subject: | |
Thank you everyone has been helpful, I will check out e bay. |
|
| Author: | jeepmedic46 [ Sun Aug 10, 2008 4:02 pm ] |
| Post subject: | |
Sold my tow hooks to my neighbor, going to look in the local junk yards for tow hooks. |
|
| Author: | mrkake [ Mon Aug 11, 2008 1:52 am ] |
| Post subject: | |
If you find them in a junk yard you can get the M Bolts from the dealer. It's probably not worth trying to get them back out if they're stuck in there. |
|
| Author: | jeepskate [ Mon Aug 11, 2008 5:19 am ] |
| Post subject: | |
The m-bolts should come out fairly easily. Mine did when I took my hooks off for an ARB bumper. |
|
| Author: | jeepmedic46 [ Mon Aug 11, 2008 12:30 pm ] |
| Post subject: | |
Going to go to the junk yard tomorrow to see if they have any tow hooks. Thank you |
|
| Author: | CrossBones [ Wed Aug 13, 2008 8:43 pm ] |
| Post subject: | |
The best deal I found was through "chryslerwinona" via ebay. Price was right and he was the closest seller to me in Northern Illinois. Parts to arrive in a few days. Looking forward to it. |
|
| Author: | jeepmedic46 [ Thu Aug 14, 2008 9:52 am ] |
| Post subject: | |
Found a set on ebay, waiting for the bidding to end on sun. |
|
| Page 1 of 2 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|