What is the diameter of the front sway bar? I need to order replacement bushings and want to get the ones with the grease zert on them. Also, if anyone knows the sizes that I would need for the bushings on the ends of the sway bar that link up to the wheel suspension that would be helpful too.

If anyone else else has done this can you let me know where you got yours, the price and what the size was that you needed to order. Thanks!

_________________
'04 Liberty Limited - 245/70/16 Firestone Destination AT's, Mopar tow hooks, Draw-Tite Class IV hitch, Skid Row Engine & Transmission Skids, Mopar T-Case & Gas Tank Skids, Extended Breather Tubes, Red Top Optima, Sylvania Silver Star head lights, Hella 500FF bumper mounted driving lights

A while back I asked a similar question. Dje Ryu (member on here) measured the diameter of the sway bar for me, turned out to be 1-7/32" which equals approximately 30.9mm.

I found this 31mm sway bar bushing with a zerk on it

http://www.jegs.com/i/Prothane/311/19-1187-BL/10002/-1

Can't guarantee you it will work. Otherwise you will have to drill and tap a zerk fitting into your OEM sway bar bushing.

All J's has Daystar poly sway bar bushings for $25

http://www.boulderbars.com/kjproducts.htm

For the sway bar end links, JBA has quick discos and oem sway bar end links and sway bar end link bushings

http://jeepinbyal.com/cat-Front_Swaybar ... ts-19.aspx

_________________
2002 Jeep KJ Sport 3.7L 4x4

245/75-16 Mastercraft Courser HSX, 16x7 Cragar, 2" OME MD Lift, ARB Bumper
AEM Brute Force Cold Air Intake, Flowmaster Super 44 Muffler

Currently working on: Full service on transmission & bed-lining ARB bumper

viewtopic.php?f=43&t=84650