Anyone know if it's OK to run without the front driveshaft? I need to order a new one - mine is thumping along with losing grease, Trying to get the correct measurements for a tom woods shaft.. Thanks Adam

_________________
2004 sport 3.7
OME coil lift.
Clevis lift.
Mopar skids.
5-speed manual.
235 70 17 Firestone destination AT'S on stock rims.
Gen 4.5 a-arms

I had an issue with my front shaft and my transfer case, and ran without the front shaft for almost a month. No problems

_________________
'03 Liberty Renegade
119,000 miles
K&N Drop-in
Factory Skids
Towing Package
245-70-16 BFG All Terrains

I ran without it for about a week. There is no problem running without it, nothings open. You'll just have 2 dead ended flanges.

_________________
02' KJ Limited/Frankenlift I HD Coils
245/75 Big Foot A/T's on Soft 8's
EBC Greenstuffs 7000
K&N Air Filter
Full set Mopar skids
Sirius Sat Radio
Cheapa$$ Subwoofer
Custom pinstripes:)

Thanks guy's , Anybody try rebuilding the old shaft ? Found this on ebay http://cgi.ebay.com/JEEP-CV-JOINT-FOR-F ... 7C294%3A50.

_________________
2004 sport 3.7
OME coil lift.
Clevis lift.
Mopar skids.
5-speed manual.
235 70 17 Firestone destination AT'S on stock rims.
Gen 4.5 a-arms

Then you need to find a shop to cut off the old one,weld the new one on(has to be perfect,no room for to short or to long on the KJ's front drive shaft),and then balance it.All said and done you will pay more then a brand new OEM one or a Tom Wood's driveshaft.