u2slow wrote:
I ordered the following Omix-ADA parts from CSE offroad:
16534.12 AXLE OIL SEAL FRONT DANA 30 KJ 02-07
16536.32 AXLE BEARING FRONT DANA 30 KJ 02-07
They showed up in Spicer boxes as 50608 and 566131 respectively; with Omix-ADA stickers added on. The bearing itself was a Koyo J-228.
They fit fine in my 2005 diff which had plastic bushings.
Hi again, do you have circlips to fix the bearing in?
the 07 that uses the plastic bush doesn't have the clips, though I do think replacing it with the torrington bearing would still work, the seal would keep it there I should think anyway. I also found another seal which is a TTO E386, it doesnt have the flange on it though it is a rubberized or metalized seal, 35mm x58mm x 10mm, I think its a candidate for a seal alternative.
The dealership in Australia charged almost $70 dollars for a single plastic bush and around $60.00 for a seal, I'm not doing that again.
If I was not in a hurry I would of bought 50 of the seals on Aliexpress for about $60.00.
Arrrrrrrggghhhh....
Thanks for you info.
_________________
KJ CRD 2.8L AUTO 2007
BP ULTIMATE
Extra Transmission cooler
2.5 inch full flow muffler.
Fuel Heater Disconnected.
In tank lift pump
Provent
Boost, EGT and Trans temp.
Engine Bay Vents soon.
Transgo Valve body (no resistor)
Hemi TC P04736587AC replaced (original TC P04736582AD in '07 KJ CRD) - Nice -:)
If im not here Im there....