Comes back as a "small evap leak". WTH?
| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| Help! Threw a code P0442 - Que es? http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=1&t=48884 |
Page 1 of 1 |
| Author: | Cacher123 [ Fri Jan 01, 2010 6:15 pm ] |
| Post subject: | Help! Threw a code P0442 - Que es? |
Comes back as a "small evap leak". WTH?
|
|
| Author: | valvestem [ Fri Jan 01, 2010 6:24 pm ] |
| Post subject: | Re: Help! Threw a code P0442 - Que es? |
The best way to track down the cause of this code is to try to find a shop with a specific tool to trace the leak, it's called a smoke machine. It is hooked into the evap system, it generates "smoke", and is the tell-tale where the leak is. Reference link:http://www.thesmokemachine.com/Full-Feature%20EVAP-Approved%20Model%206525.html |
|
| Author: | DryBones [ Mon Jan 04, 2010 9:20 pm ] |
| Post subject: | Re: Help! Threw a code P0442 - Que es? |
gas cap or in my case it was 2 small tubes back by the firewall on the drivers side, just about the manifold. Dry,brittle and cracked from the heat probably. Replace with some fuel line tubing from Advanced Auto. Could also be some of the tubing down by the gas tank too. |
|
| Author: | Cacher123 [ Thu Jan 07, 2010 2:25 pm ] |
| Post subject: | Re: Help! Threw a code P0442 - Que es? |
Jeep reset the code. It hasn't come back (yet). Do I need to do anything? |
|
| Author: | DryBones [ Mon Jan 11, 2010 10:02 pm ] |
| Post subject: | Re: Help! Threw a code P0442 - Que es? |
not if it doesn't come back. it could have been the gas cap not sealed properly. |
|
| Author: | JJsTJ [ Tue Jan 12, 2010 9:18 am ] |
| Post subject: | Re: Help! Threw a code P0442 - Que es? |
Very common spot for this is the rubber hoses going into the vapor canister forward of the gas tank, above the axle. I've seen the hose there crack on a few KJ's now. |
|
| Author: | Neatus [ Tue Jan 12, 2010 9:34 am ] |
| Post subject: | Re: Help! Threw a code P0442 - Que es? |
JJsKJ wrote: Very common spot for this is the rubber hoses going into the vapor canister forward of the gas tank, above the axle. I've seen the hose there crack on a few KJ's now. I had this vaccum leak my second year of owning the KJ. Have heard of a few others getting it as well. |
|
| Author: | IceColeNH [ Sun Jul 18, 2010 9:35 am ] |
| Post subject: | Re: Help! Threw a code P0442 - Que es? |
help please. Just recently replaced all the rubber hoses (many were baaaaaad.) I believe. Traced lines, dropped tank etc. Replaced cap. LDP. Fresh air filter. 442 came back. Cleared it again. Seeing if it comes back. I have gained some ground as I originally had a 455 too. However, during fillups. After the tank is about half full. The fuel pump will stop each 1/2 to gallon and require resetting nozzle. Continuing till full. I am wondering if I reinstalled the little green and black valve wrong or it may be bad. This is the one behind the fuel filler for the line that runs to the flow management valve. It is in black side up. It also clicks when shaken. I sure its a cheap part. Dealer parts closed today. I just concerned that there could also be something else wrong. So, I test the the check valve. It is questionalble at best. There is one just like it that runs to the brake booster. That one doesn't click. I go to parts stores to no avail. The stealership can't find a picture of it. However, finds "the parts assembly." No picture. $52.00. I could see 5 maybe. I ask if it is the whole filler tube assembly. He can't tell me. Could be the valve and 2ft of 5/16th hose for all he knows. Goodbye. I'll continue my quest. Oh, the 442 is back. I ask if this valve could be the culprit. Maybe.... thank you for any advice and input. Jeff. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|