Does anyone have a front shock laying around? Or maybe you already have this dimension... I was wanting to make some aluminum shims/sleeves (instead of the conduit nuts) to use for my clevis lift. I know someone posted a quick drawing of one a year or so ago. But I searched and can't find it. So, if someone can measure the OD of the clevis end our front shocks, I would be greatly appreciative. Just need the shock OD, so I know what ID to make my sleeves. I'd get under mine and measure it myself, but it is all wet and nasty here.

_________________
2007 Light Khaki 4x2 Sport
- Debadged - LTT CAI with Amsoil Filter - JVC HD Radio - Infinity BassLink
- Iggee Seat Covers - Black Moabs - 265/75-16 Cooper Discoverer ATP - 4.10's
- DIY Franky sitting at 23.75" - Al's 4.5 UCAs - Trimmed F&R Bumpers
- Removed Rear Sway Bar - Removed Rear Vibration Damper
- 75k miles so far...

Well the conduit nuts are like 2 .25 or so
I have some specially cut ones someone sent me to try and they are 2.185 I.D. are are too snug, so somewhere in between would get you in the ball park. O.D. is about 3 7/8


Duh wait just remembered that I have an extra set of front shocks out there. I think with what I measured ( of course I do not measure down to 2.2476593 ) but the 2.25 lets it slide over the shock easliy. Going smaller would require that you have a slot in one side of it of course

_________________
MUDD'S MOTORSPORT'S We do IFS lift installs ,
03 OVERLAND EDITION /Kilby-Skidrow-Mopar-4XGuard skids/ 2.5 inch TOTAL CONTROL JBA coilovers -JBA Arms/MOABS-31 FALKEN WILDPEAK AT3W / 4.10's etc, 04 Kilimanjaro Edition loaded, plus 05 KJ limited

Here you go, I made 2 sets 3/8 and 14/ inch. I run the 3/8 on my ome 1/4 inch for future use. Have fun



[/img]

_________________
“You cannot solve a problem from the same consciousness that created it."

“Learn from yesterday, live for today, hope for tomorrow. The important thing is not to stop questioning.”