Hi, does anyone know if the door moulding bump strip from a later kj stainless steel type will fit an earlier 2004 model. Are they held on with double sided tape or trim clips.

_________________
2004 2.8 crd Limited

02-07 Is the same on the door moldings. Held on by 2 way tape...little pins 1 inch/12mm are on the back for lining up the moldings....Chris

I have been thinking about taking mine off. I wasn't sure if there were any holes in the door, hearing that it is just tape has me thinking again.

_________________
06 White KJ Sport 4x4
http://www.cardomain.com/ride/2432458/1

It's tape but there are holes in the door for the alignment pins that Chris talked about.........HJ

_________________
☀lllllll☀Black 05 CRD Splimited, Track Lock, Select Track, Suncoast TC, Transgo shift kit
GDE Hot Tune & Trans Tune, K&N Filter minder, Green Air Filter, Magnaflow 1226
LT245/75/16 BFG AT, EVIC, INPro LED 3rd Brake Light, V6 Airbox
LED Courtesy Lts & Rear floor Lts, Halo Key Light
02 Radio Bezel with ashtray & LED light ☀lllllll☀

Yeah, if you don't replace them with something else, or reshape the door with bondo or something, it would look quite funny..
I thought about replacing the ones that have "Liberty" 'engraved' in the plastic with the earlier model style that just has a little "ripple" in it.

_________________
-dbk
SOLD2007 6 Speed - Projector Retrofit -Custom LED Tail Lights - Lights on Cowl & 130w 8" ProComps - Full Skids-RockLizard Super Skink Sliders-Front Hitch
Frankenlifted-Al's A-Arms-Goodyear Duractracs 31x10.5R15x7 Cragar D Window 4"bs-Cobra 75WXST - 4' Firestick
4.10s sitting in a box - 3
Sold-1988 Suzuki Samurai
2002 Jeep TJ