| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| need some info http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=1&t=53833 |
Page 1 of 1 |
| Author: | JeepBumm68 [ Sat Jun 26, 2010 10:11 pm ] |
| Post subject: | need some info |
Ok need some info. Its for a buddy. he has an 06 liberty. 1.One is there a write on how to take the door panels off without ripping everything apart 2.what does it take to get the stock flares off, without ruining what holds them in. |
|
| Author: | audiboy86 [ Sat Jun 26, 2010 11:53 pm ] |
| Post subject: | Re: need some info |
PANEL TOOL is all i have to say and dont forget the 2 screws as for the flares i couldn't get mine off with tearing my clips all to pieces.Hopefuly someone can help you and me b/c i have to take my flares off in a few weeks. |
|
| Author: | Fulltimer [ Sun Jun 27, 2010 4:18 am ] |
| Post subject: | Re: need some info |
If your real lucky the plastic clips holding on the flairs on will work again. The dealer charges an arm and leg for them. Terry |
|
| Author: | audiboy86 [ Sun Jun 27, 2010 10:41 am ] |
| Post subject: | Re: need some info |
Well i live on ebay and i found these wonderful things on here and have ordered 2 sets of them for when i take mine off.http://cgi.ebay.com/ebaymotors/15-CHRYS ... ccessories |
|
| Author: | SavageUrge [ Sun Jun 27, 2010 5:21 pm ] |
| Post subject: | Re: need some info |
Those clips are also available at NAPA for not a lot of $. I believe they come in packs of 14 or so. I don't recall the p/n though, sorry. |
|
| Author: | Sir Sam [ Sun Jun 27, 2010 6:07 pm ] |
| Post subject: | Re: need some info |
I had no trouble getting my flares off, didn't break a single clip. don't recall how I did it, but it was not hard. |
|
| Author: | HoosierJeeper [ Mon Jun 28, 2010 10:01 pm ] |
| Post subject: | Re: need some info |
For the door panels coming off, it's easy. Done it a few times on mine. 1. Behind the door handle, remove the little cover. 2. Remove that screw 3. In the arm rest cubby, there is another screw. 4. Remove that screw. 5. With a wide putty knife, gently pry under it the door panel. 6. Keep doing that until all the clips are out. |
|
| Author: | JeepBumm68 [ Sun Jul 04, 2010 11:43 pm ] |
| Post subject: | Re: need some info |
thanks guys |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|