So, I dropped all my suspension goodies off this morning with my Jeep at a local mechanic. He told me installation should be no problem. He called back and said he is having problems with the rear. Then went on to say that instead of putting the additional bumpstop on the bottom plate, he replaced the top factory one with it
So I just faxed him over instructions that took me about 2 min to find. Is this really that difficult of an installation for a mechanic. I have done my own suspension work in the past and would have done this one if it wasnt for my health problems. I dont recall it being that troublesome with the proper tools. Should I be very concerned he is going to screw this all up? He also said the rear is sitting up very high. All I have is OME springs and Blistein shocks....it cant be that high up
Found out my rear springs were totally collapsed so it does look much higher than before. Its dark already here so ill make sure i post some pics up tomorrow. Joining the lifted crew feels pretty good.
