Cleared the Codes today for another run:
Here's what the results were when I pulled the current codes vs what was there the last time:
PREVIOUS CODES THAT DISAPPEARED: P0700 - Generic Code from TCM Usually Followed by my specific codes P1698 - No CCD Messages Received From The TCM P0841 - LR Pressure Switch P0884 - Power Up @ Speed
PRE EXISTING CODES STILL PRESENT: P0888 - Trans relay output Always OFF P0846 - 2C Pressure Switch P0871 - OD Pressure Switch P0988 - 4C Pressure Switch P0876 - 4D Pressure Switch P0158 - 2/2 O2 Sensor (Still needs replaced) P0455 - Evap System Leak (Fixed with new gas cap, code is gone)
NEW CODE: P0442 Evap Emissions Control System Leak
Cleared all codes today. Check engine light was off for exactly 20miles before it came back on. Still no issues with the transmission shifting and its been 115 miles since it stopped acting up.
I have posted this before and got only one answer. Well they guy went cleared all his codes, and after 20miles of driving here is what popped back on again. The tranny has been doing some type of dead bs with not wanting to shift into 4th and 5th for awhile, he got a flush and seemed to help it now.
_________________ 2005 Jeep Wrangler Rubicon TJ- Impact Orange
4'' RK LA, 35's KM2's, Warn front bumper, Warn rear bumper with tire swing, Warn gas skid, Nth oil skid, 4.88's, Alloy axles shafts F&R, Rokmen Corner armor with led's, and Rokmen sliders, custom back-up lights from gen-right, piaa 510's, IPF green glow fatboy's up front.
|