LOST JEEPS
http://www.lostjeeps.com/forum/phpBB3/

ECTED by Auburn Gear
http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=1&t=6008		 Page 1 of 1
Author:  the1jferg [ Mon Feb 20, 2006 7:12 pm ]
Post subject:  ECTED by Auburn Gear
YAHOO, My ECTED gets installed next Wednesday.

Waste-N the Money :lol: :lol: :lol:

http://www.auburngear.com/oemdifferentials/ected/

http://www.auburngear.com/oemdifferenti ... rature.pdf
Author:  Jeepjeepster [ Mon Feb 20, 2006 7:43 pm ]
Post subject: 
Please say more, ive never heard of this. How much? Where? Must you have abs or traction control to use this?
Author:  the1jferg [ Mon Feb 20, 2006 9:15 pm ]
Post subject: 
http://www.4wheelerssupply.com/catalog/ ... s_id/71421

Trust me, I hate being the Guinea pig. No those things you mentioned are not requirements. I'm not sure if they make an 8.25 ECTED.

This has been an expensive process for me. I have replaced my bearings, races and seals going on my 3rd time too for GP's and only 40K. If I do it, I do it up. :wink:

I found Charmin Toilet paper with Aloe was worth the $$ and the wait.

I don't have ABS, but my diff is set up for it, thus the problem with other DANA 35 products fitting. Its the only option I have right now because of my ABS tone ring issue. I'd still run a tru-trac any day of the week but they won't honor the warranty if I screw it up by machining it to fit.

The good thing is I can either push the button or get up to 100% lockup from limited slip, yes thats right 100% from a limited slip.

I would hands down take this ECTED over the ARB Air locker or my PowerCrax hell knocker :lol: :lol: :lol: Sorry SETH.

Dropp-N a Ryme Bomb like a Time Bomb :lol: :lol:

This post created with Sam Adams :lol: :lol: :lol:

P.S. Eddo, 8.25 -- I don't know,did you check. Says they make the Dana 30
Author:  Eddo [ Mon Feb 20, 2006 9:18 pm ]
Post subject: 
That sounds like a nice product. Too bad they don't make if for the 8.25"
Author:  Tokyojoe [ Mon Feb 20, 2006 10:34 pm ]
Post subject: 
You put a Dana 30 on your rear?
Author:  ManicMechanicJoe [ Tue Feb 21, 2006 3:13 am ]
Post subject: 
the1jferg wrote:

This post created with Sam Adams :lol: :lol: :lol:



hahahahaha...you know ferg, it may have been cheaper and easier for you to just swap in an 8.25...
Author:  the1jferg [ Tue Feb 21, 2006 9:37 am ]
Post subject: 
Joe,

I could not find one (8.25) anywhere over the last 3 years...Very bizzare?

It was over $2300 to get it from the dealer.

This post created with Henry's blend (whole bean) ground in a KitchenAid model A-9 :lol:
Author:  kjrenegade [ Tue Feb 21, 2006 10:27 am ]
Post subject: 
I agree, that is a great product, and well worth the extra money...

The only problem is, sometimes the aloe makes me feel like I have swamp-ass even when I don't..

:-)r :-)r :-)r
Author:  Guyute1210 [ Tue Feb 21, 2006 1:16 pm ]
Post subject: 
kjrenegade wrote:
I agree, that is a great product, and well worth the extra money...

The only problem is, sometimes the aloe makes me feel like I have swamp-@$#% even when I don't..

:-)r :-)r :-)r


OMG...I was thinking the same thing...but he went there... :-)r
Author:  the1jferg [ Tue Feb 21, 2006 1:20 pm ]
Post subject: 
Eddo, You are correct, they don't make it for the 8.25, Maybe they will someday.
Author:  Edwin [ Tue Feb 21, 2006 7:21 pm ]
Post subject: 
Tokyojoe wrote:
You put a Dana 30 on your rear?


HEY the1jferg! :lol: :lol: :lol:
Author:  Jeepjeepster [ Tue Feb 21, 2006 9:05 pm ]
Post subject: 
I am still confused at what this is. Is it a locker? From what I read it works off the abs sensors? Is it like traction control but doesnt use brakes to stop the wheel from spinning?
Author:  the1jferg [ Tue Feb 21, 2006 11:20 pm ]
Post subject: 
Limited slip and a locker when you push the button.

Some of the features is future stuff. I just like the basics
Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/