Replacing HP steering hose, need to know O ring size

BjBnet · **Posted:** Thu Apr 14, 2011 3:02 pm

Long story short, I bought a set of new Edelmann HP steering hoses and it came with everything but the O rings which states they are included. The parts store say they don't know the size and have no more of those kits (80477) in stock to check but they said they will get me some O rings if I could get the size and type of material they are made of.
I tried calling Edelmann but that's a waste of time...menu after menu and then "please leave a message"

Anyway, does anyone here know what size O rings that go on the end of the fittings?
Thanks!

ridenby · **Posted:** Thu Apr 14, 2011 6:39 pm

Could not find size listed in FSM. When I did mine just used a little green one,kind of a square profile to it. I know this isn't much help.

tjkj2002 · **Posted:** Thu Apr 14, 2011 10:36 pm

BjBnet wrote:

Long story short, I bought a set of new Edelmann HP steering hoses and it came with everything but the O rings which states they are included. The parts store say they don't know the size and have no more of those kits (80477) in stock to check but they said they will get me some O rings if I could get the size and type of material they are made of.
I tried calling Edelmann but that's a waste of time...menu after menu and then "please leave a message"

Anyway, does anyone here know what size O rings that go on the end of the fittings?
Thanks!

Have them order another hose and make sure the o-rings come with it.It's not a oridinary o-ring and you can not use a rubber o-ring either as it will be eaten away by the ATF+4.

BjBnet · **Posted:** Fri Apr 15, 2011 7:35 am

tjkj2002 wrote:

BjBnet wrote:

Long story short, I bought a set of new Edelmann HP steering hoses and it came with everything but the O rings which states they are included. The parts store say they don't know the size and have no more of those kits (80477) in stock to check but they said they will get me some O rings if I could get the size and type of material they are made of.
I tried calling Edelmann but that's a waste of time...menu after menu and then "please leave a message"

Anyway, does anyone here know what size O rings that go on the end of the fittings?
Thanks!

Have them order another hose and make sure the o-rings come with it.It's not a oridinary o-ring and you can not use a rubber o-ring either as it will be eaten away by the ATF+4.

Ya that's what the guy was concerned about. He wasn't sure about the tranny oil being safe or not. Thanks again Troy

BjBnet · **Posted:** Sat Apr 16, 2011 7:24 am

never mind, dealer has them.... 5 bucks each :dizzy:

Replacing HP steering hose, need to know O ring size

Who is online