LOST JEEPS
http://www.lostjeeps.com/forum/phpBB3/

Installing a RB1 / RB3 Navigation Unit
http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=1&t=6077		 Page 1 of 1
Author:  nisiotis [ Wed Feb 22, 2006 7:43 pm ]
Post subject:  Installing a RB1 / RB3 Navigation Unit
Hi everyone.

Recently I bought a RB3 Navigation Unit (used from a Chrysler PT Cruiser owner).
I found some installation pictures for RB1 unit on GC but not for the Liberty. Anybody knows where is the Nav Antenna should be installed?

Thanks a lot,
Author:  Jeepin Al [ Wed Feb 22, 2006 8:11 pm ]
Post subject:  Antenna
the antenna fits over the speedo cluster, towards the front of the windshield under the dash pad. You need to remove the top of dash.

Al
Author:  Gentleman [ Wed Feb 22, 2006 9:06 pm ]
Post subject: 
Curious about your location because I have read that the RB3 was not for the North American market

Bob
Author:  0311_DoC [ Wed Feb 22, 2006 10:56 pm ]
Post subject: 
Gentleman wrote:
Curious about your location because I have read that the RB3 was not for the North American market

Bob


by nisiotis...
05 Jeep Cherokee (KJ) 2.4L Dark Khahi :wink:
Author:  roadrunner [ Thu Feb 23, 2006 4:10 am ]
Post subject: 
The RB3 is the European version of the RB4. You may have a problem with the radio frequencies with the RB3 in the US. They would also use different data disks.

Here's the antenna installation: http://www.jeepkj.com/forums/viewtopic.php?t=642

Here's the radio part (all the radios use the same procedure):
http://www.jeepkj.com/forums/viewtopic.php?t=317

Here's some more info on the RB3 and RB4:
http://www.wjjeeps.com/nav_rb4.htm[/u]
Author:  nisiotis [ Thu Feb 23, 2006 6:23 pm ]
Post subject: 
Thanks everybody for your answers...

Gentleman i am from Greece. RB3 is the European version of RB4 Navigation unit from Harmon International.

Thanks again...
Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/