Quick question...

If I am MIG welding on the vehicle body am I ok to just disconnect the battery?

Don't want to fry anything electronic.

This is actually for my TJ, I am fabbing a rear bumper and need to tack the bumper to custom mounts I am making while on the vehicle for alignment.

Thanks!

_________________
2005 Jeep KJ Renegade. 2.5" Rusty's Lift, 3/8" Clevis Lift (custom Spacers), BFG 245/75R 16 AT, 1/25" torque stud wheel spacers, Light Bar, all factory skids.

2004 Jeep TJ Sport. 2" Terraflex lift, BFG MT/KM 31x10.5, Front sway bar disco, Cobra 75.

1990 Jeep XJ. 2" spacer lift. POS won't start!

just disconnect the negative battery terminal and you will be fine. I've done it many times myself.

_________________
04 Rocky Mountain Edition
Detroit Truetrac in the front, Rusty's 2.5" Coil Lift, Revos
Custom Roof Rack w/ 4 Hella 500s, Optima Red Top, Mopar Rock Rails, All Mopar skids

Great! Thanks..

_________________
2005 Jeep KJ Renegade. 2.5" Rusty's Lift, 3/8" Clevis Lift (custom Spacers), BFG 245/75R 16 AT, 1/25" torque stud wheel spacers, Light Bar, all factory skids.

2004 Jeep TJ Sport. 2" Terraflex lift, BFG MT/KM 31x10.5, Front sway bar disco, Cobra 75.

1990 Jeep XJ. 2" spacer lift. POS won't start!

If you weld on the "frame " part next to the floor boards be careful, the main wiring harness runs througth the upper part on the channel.

Al

_________________
One Ruby, One Grand Cherokee, One YJ, One disassembled CJ, one Chevy Mason dump, one hotrod IH Pick-up, couple of antique tractors.
Former owner of a 5.5 inch lifted KJ

Wrong location for this question. Should be in the General section. This section is for people with Fab ideas. Just FYI

_________________
===
New KJ Gear - Desert Armor Flak

2004 Renegade Light Khaki - 4" JBA Lift - Rock Lizard Products: Komodo Dragon Rear Bumper, Prototype Winch-mount Front Bumper, Super Skink Sliders - All J's Super Tranny Skid II - 31" Firestone Destination AT's on Moab wheels - Cobra 75W CB w/ stock Antenna mod

[b]Retired, US Military