My alignment is maxed out

Kks03kj · **Posted:** Sat Feb 18, 2012 4:20 pm

So my alignment is maxed out on uca and was wondering if there is a extender bolt or something besides rro uca or jba's

Kinda newto this stuff :lol:

Running a 03 Libby with 3" lift

And also looking into getting rid of the front spacer what's a good 3" setup for the front

Thank you

tommudd · **Posted:** Sat Feb 18, 2012 6:17 pm

No extender bolts
good alignment person should be able to get it close enough to where it will handle and tires will wear good
Don't even think of RRO UCAs , JBAs only
What spacer lift do you have and where do you sit ( measure from middle of wheel to bottom of flare in the front)

Kks03kj · **Posted:** Sat Feb 18, 2012 7:09 pm

Rough country 3"

and I'll measure When the its back at home lol

tommudd · **Posted:** Sat Feb 18, 2012 7:25 pm

get some OME 927 springs in front good set of either Bilstein or OME shocks , then add some teraflex front bumpstops. The springs will give you about 2.25-2.5 inches of lift if you want 3 add a 1/4 inch top plate or 3/8 inch clevis and you'll have the 3 inches you want
Then proceed to the rear :wink:

All3Sports · **Posted:** Sat Feb 18, 2012 7:26 pm

Wont be at 3 inches for long with that lift.

Kks03kj · **Posted:** Sat Feb 18, 2012 7:50 pm

All3Sports wrote:

Wont be at 3 inches for long with that lift.

Yea it doesn't look like it is anymore

I ordered bumps stops yesterday

Kks03kj · **Posted:** Sun Feb 19, 2012 12:11 am

tommudd wrote:

No extender bolts
good alignment person should be able to get it close enough to where it will handle and tires will wear good
Don't even think of RRO UCAs , JBAs only
What spacer lift do you have and where do you sit ( measure from middle of wheel to bottom of flare in the front)

Do you know what the stock height is?

Kks03kj · **Posted:** Sun Feb 19, 2012 12:28 am

tommudd wrote:

No extender bolts
good alignment person should be able to get it close enough to where it will handle and tires will wear good
Don't even think of RRO UCAs , JBAs only
What spacer lift do you have and where do you sit ( measure from middle of wheel to bottom of flare in the front)

right now there sitting about at 21 all around

tjkj2002 · **Posted:** Sun Feb 19, 2012 8:30 am

Kks03kj wrote:

right now there sitting about at 21 all around

So your only at 2" of lift over stock.

tommudd · **Posted:** Sun Feb 19, 2012 9:15 am

And at 21 you should have no problems getting an alignment done unless you have other issues or someone that doesn't know how to align one ( even with stock UCAs)

My alignment is maxed out

Who is online