only works adding 2 conduit spacers any more requires disassembly but here is how it went

1. Lift vehicle
2. Remove caliper
3. Loosen fork (top bolt)

4. Take canduit cut with bolt cutters or dremal (one cut)
5. grab with vice grips
6. Heat with map gas torch
7. Spread open (once hot)

8. Remove bolt from fork ( top one)
9. Pry top of fork open so it can slide up and down (aka pry in the gap from where the bolt came out of)
10. Take pry bar place right under strut ( but above fork)
11. Use leverage to slide fork down (creating gap between strut bottom and fork top)
* be conscious of cv boot*
12. Take (already "opened conduit") and place in gap
13. Reheat conduit
14 pinch closed
15 re insert the forks top bolt
16. Bot caliper back on
17. Put wheel back on
18. DONE

Please note that I could not fit more then 2 conduit spacers without dropping lower control arm
But it is still a easy way to add 2
Hope this can help some people

_________________
2006 kj 6spd white
skyjacker platinum lift with Conduit Clevis lift,
JBA 4.5 UCA
JBA shaved dow CV's
Detours Backbone Bumper System,
Smittybilt 8000lb synthetic line winch, surco roof rack
Cragar Soft 8 Silver Wheels
4.10 gears, 245/75/16 Wrangler Authority A/T
Pinch welds annihilated
Class III rear hitch



HOPEFULLY adding a snorkel soon