| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| Easiest conduit spacer Clevis lift no disassembly http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=1&t=65612 |
Page 1 of 1 |
| Author: | Usmc631 [ Sun Mar 04, 2012 1:42 am ] |
| Post subject: | Easiest conduit spacer Clevis lift no disassembly |
only works adding 2 conduit spacers any more requires disassembly but here is how it went 1. Lift vehicle 2. Remove caliper 3. Loosen fork (top bolt) 4. Take canduit cut with bolt cutters or dremal (one cut) 5. grab with vice grips 6. Heat with map gas torch 7. Spread open (once hot) 8. Remove bolt from fork ( top one) 9. Pry top of fork open so it can slide up and down (aka pry in the gap from where the bolt came out of) 10. Take pry bar place right under strut ( but above fork) 11. Use leverage to slide fork down (creating gap between strut bottom and fork top) * be conscious of cv boot* 12. Take (already "opened conduit") and place in gap 13. Reheat conduit 14 pinch closed 15 re insert the forks top bolt 16. Bot caliper back on 17. Put wheel back on 18. DONE Please note that I could not fit more then 2 conduit spacers without dropping lower control arm But it is still a easy way to add 2 Hope this can help some people |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|