Hey everyone,

So the liberty is in need of some new ball joints, or at least I'm fairly sure that's what it is, and I know that there was a recall done to the Jeep and have heard rumors of people getting them replaced for a lifetime. Has anyone had them replaced and if so did they give you any trouble for the upper ones as well?

If its not covered how hard is it to do something like this? Is it something I could do myself never doing them before? Keep in mind I do light work to the Jeep myself. Thanks for any insight guys.

_________________
2005 KJ Flame Red
3.7 4x4 Limited Edition
Rancho RS9000 Shocks
Hypertech Tuning Chip


***Words to live by***
-God
-Family
-Jeeps
-Guns
-Friends
and in that order too

Uppers aren't too bad to do , 4 bolts total , 2 per side plus pop off the ball joint
You can get replacements from jeepinbyal that are greaseable
or buy stockers again

_________________
MUDD'S MOTORSPORT'S We do IFS lift installs ,
03 OVERLAND EDITION /Kilby-Skidrow-Mopar-4XGuard skids/ 2.5 inch TOTAL CONTROL JBA coilovers -JBA Arms/MOABS-31 FALKEN WILDPEAK AT3W / 4.10's etc, 04 Kilimanjaro Edition loaded, plus 05 KJ limited