what is the bolt size and threading for the KJ

_________________
With enough fabbing, time & $, it's certainly possible.
That being said, it's like boinkin' your sister...just because you can, doesn't mean you should.

M12x1.75

thanks troy

_________________
With enough fabbing, time & $, it's certainly possible.
That being said, it's like boinkin' your sister...just because you can, doesn't mean you should.

Are there bolts in the holes now? If not, I would recommend running a tap through them. I had to when installing my hitch.

_________________
2006 Sport, GDE FT Eco Tune, Custom Trans Tune
2015 Ram 1500 Big Horn EcoDiesel, GDE Hot Tune

Tapping with a WD-40 covered bolt worked out pretty well for me too.

_________________
'04 Silver KJ

-OME927 springs/90009 shocks in the front and JBA 4" springs/Monroe Load Levelers. 3/8 inches of top plate, conduits, and JBA UCAs.
-LT265/70/16 Hankook Dynapro ATM, Load Range D2
-Magnaflow Muffler
-Sport 4x4 Hood Decal
-Altezza Tail Lights, all LED bulbs and load resistors, LED third tail light
-IRO UCA w/ Iron Forge Customs bracket

Be very careful doing it that way, don't force it too hard or it could result in damage. A carbon steel bottom tap works very well to clean threads but be careful not to cut new ones.

_________________
2010 KK Deep Water Blue,OME Liftplus 1",JBA 5.5 UCA ,Dynaflow cat back exhaust, Weathertech VV & mats,Mopar skids,Atthehelm front bumper, Smittybilt XRC 10, Rigid LED's,RL Skink Supersliders,Gecko Safari Basket Detroit Truetrac rear, E-Locker front, G2, Dana 4.10's

Either can do damage to threads! It worked out 6 times in a row so I'm good...

_________________
'04 Silver KJ

-OME927 springs/90009 shocks in the front and JBA 4" springs/Monroe Load Levelers. 3/8 inches of top plate, conduits, and JBA UCAs.
-LT265/70/16 Hankook Dynapro ATM, Load Range D2
-Magnaflow Muffler
-Sport 4x4 Hood Decal
-Altezza Tail Lights, all LED bulbs and load resistors, LED third tail light
-IRO UCA w/ Iron Forge Customs bracket