LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
A nonworking turn signal http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=1&t=87160 |
Page 1 of 1 |
Author: | HER_CRD [ Sun Sep 10, 2017 4:54 pm ] |
Post subject: | A nonworking turn signal |
I have a front left turn signal that would intermittently not work. Once I would start troubleshooting, it would work again for a while. Now it's stopped working and I believe I have found the issue. There seems to be a bad connection at what I believe is #C107. The connector is tucked up inside the fender well and clipped to the bumper. The issue seems to be on the side without the red clip as I can wiggle the wires at the connector and make the light work intermittently. From what I can tell, the Mopar repair kit associated with this connector is 05019938AA, but I'm having trouble finding a source for it. Does anyone have any leads this? Sent from my HTC6525LVW using Tapatalk |
Author: | HER_CRD [ Sun Sep 10, 2017 7:31 pm ] |
Post subject: | Re: A nonworking turn signal |
This connector kind of looks like it could be the same as this headlight socket connector. I'll have to see if Auto zone has one in stock so I can check it out. http://m.autozone.com/collision-body-pa ... 10232900:s Sent from my HTC6525LVW using Tapatalk |
Author: | joe_ [ Sun Sep 10, 2017 9:17 pm ] |
Post subject: | Re: A nonworking turn signal |
If you have a junkyard near you, you could probably grab one there for cheap. |
Author: | Billybob [ Mon Sep 11, 2017 3:53 am ] |
Post subject: | Re: A nonworking turn signal |
Separate this connector and with a small Jewelers' screwdriver carefully very slightly pry close all the female pins so as to make a firmer contact....don't overdo it as then the pins will refuse to mate together. |
Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |