LOST JEEPS
http://www.lostjeeps.com/forum/phpBB3/

Clutch pedal measurements.
http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=1&t=92456
Page 1 of 1

Author:  Titan Joe [ Sat Aug 20, 2022 2:55 pm ]
Post subject:  Clutch pedal measurements.

I'm making a clutch pedal for a 2005 jeep liberty from a brake pedal. The only thing I need to figure out is the distance from the pivot to the rod pin. I can make up and align the rest, but I want to get the factory ratio for pedal travel and that will solve that. I can use a measurement from the center of the rod pin to either the edge of the pivot pin or the center. Just specify which one it is. I know it will be a little hard to measure in the vehicle since the clutch linkage is pretty far to the outside.

I wanted to post a picture, but it appears that you have to just provide a link to an already hosted picture instead of being able to attach them to a post in this forum.

Thanks for your help!

Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/