CRD runs fine till warm up, then stalls out

Inspectorrobb · **Joined:** Tue Oct 15, 2019 11:12 am **Posts:** 17

06 Liberty CRD.
Stalls out when driving normally, after it warms up. Starts right back up, drives for a mile or so, stalls. Starts up.

Replaced the Crankshaft Position Sensor, has the stage 2 EGR delete, just changed the timing belt, replaced the broken air hose to turbo that was cracked, but it did the stalling thing before all this. Replaced fuel filter.

No odd codes. It had some egr stuff prior to the delete, and a couple glow plugs needed replaced, but that was it.

What else could be the cause of it stalling, but starting right back up and drives fine otherwise.

Do I need to do the relearn procedure for the cps to get it to stop stalling?

WWDiesel · **Posted:** Sun Nov 16, 2025 10:11 pm

Do you have a lift pump?
When it stalls, have you tried pumping up and bleeding the fuel filter?
Could be a defective CPS that you installed? They crap out when going through the heat up cycle.
Camshaft position sensor?
You got to figure out if it is fuel related or electrical.
Do any codes reveal any clues?

Inspectorrobb · **Joined:** Tue Oct 15, 2019 11:12 am **Posts:** 17

So a few codes come up.

P1186 Low Fuel Pressure
P0093 Large Fuel System Leak
U0121 Lost communication with ABS
U0146 something about Lost communication with gateway A ?

and of course all the codes for when you delete the EGR
And I replaced the glow plugs and now get all the p0671-2-3-4

No lift pump on this one. I do have one in another wrecked jeep I can move over if I need to.

So would the Low fuel pressure and Large Fuel system leak make it just shut down when warm? I do tend to see it happen when you press the accelerator. Then it starts back up. It might crank for 4-5 seconds but it starts up and runs fine, till it dies in a random time frame.

WWDiesel · **Posted:** Wed Nov 19, 2025 5:24 am

These are key:

Quote:

P1186 Low Fuel Pressure
P0093 Large Fuel System Leak

Your CP3 is starving for fuel on the suction side when under load.
Install an intank fuel pump, it will solve your problem.

CRD runs fine till warm up, then stalls out

Who is online