Hi everyone, can someone help me with the torque values on a 2009 KK 2.8 CRD Jeep Cherokee, head bolts.It will be much appreciated?

_________________
2009 Jeep Cherokee (SA)
2.8 CRD Limited

Was not able to find a Factory Service Manual for the 2009 Model KK online. But if the engine is the same as the 05-06 2.8 CRD engines, you can view the Factory Service Manuals for them which covers the instructions and torque sequences for the head bolt installation.
View Factory Manuals at:> https://www.colorado4wheel.com/manuals/Jeep/KJ/
Instructions start in Section No. 9, page 197 in the 2005 FSM. See Picture No. 1

PLEASE NOTE: Many owners opt to replace the problematic stretch to yield head bolts with ARP head studs which are NOT stretch to yield and are installed with simple torque figures rather than the complicated degree method used on factory head bolts. See Picture No. 2
https://www.idparts.com/arp-head-stud-k ... -4044.html

CYLINDER HEAD BOLT TORQUING INSTRUCTIONS FOR 2005 VM 2.8 CRD ENGINE


ARP HEAD STUDS:

_________________
Supporting Vendor and Moderator of LOST
05 Jeep Liberty CRD Limited
Ironman Springs/Bilstein/Shocks
Yeti StgIV Hot Tune
Week's BatteryTray
No FCV/EGR
Samcos/ProVent
SunCoast/Transgo
Carter Intank-pmp
2mic.Sec.Fuel Filter
Flowmaster/NO CAT
V6Airbox/noVH
GM11 Bld.fan/HDClutch
IronrockArms/wwdieselMount
98 Dodge Cummins 24 Valve

Thank you WWDiesel, appreciate the prompt response

_________________
2009 Jeep Cherokee (SA)
2.8 CRD Limited