| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| write up for flowmaster http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=104&t=54106 |
Page 1 of 1 |
| Author: | Coliniksi [ Thu Jul 08, 2010 12:11 pm ] |
| Post subject: | write up for flowmaster |
Got my muffler today, was wondering if any one had a "how to" install on this, any advise would be apreciated, this is my first time instalin a muffler thanks in advance |
|
| Author: | clacker [ Thu Jul 08, 2010 6:25 pm ] |
| Post subject: | Re: write up for flowmaster |
first, get a fat zero-impact hammer (i.e. a big rubber mallet). Loosen the nut on the end of the existing exhuast and proceed to beat the ever living hell out of it with that mallet. a lil bit of WD40 may make the job a lil easier also. once u get the muffler disconected, ull have to remove the rubber hangers that keep the whole thing suspended under the body. once those hangers are off, itll take a lil jimmying and patience to manuver the stock muffler/tailpipe out from under. Once the stock guy is out of the way, use a bit of WD40 and wipe it around the end of the piping after the resonator and then using that mallet again, whack that new exhuast on. Id would recomend using 2 of those "U"-shaped mounting brackets in stead of just 1 to hold it in place. Crank down on those brackets til u cant anymore and viola, your good to go. |
|
| Author: | Coliniksi [ Thu Jul 08, 2010 6:35 pm ] |
| Post subject: | Re: write up for flowmaster |
awsome thanx man |
|
| Author: | clacker [ Thu Jul 08, 2010 6:39 pm ] |
| Post subject: | Re: write up for flowmaster |
as long as the exhaust isnt still hot, just grab it with both hands and kindas twist it around a bit innitially to kinda loosen it up b4 u take that mallet to it |
|
| Author: | Coliniksi [ Fri Jul 09, 2010 1:56 pm ] |
| Post subject: | Re: write up for flowmaster |
so i don't need to cut anything? |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|