Not sure if this has been posted yet, but, If you are looking to upgrade wheels and don't want the extra hassle of finding ones that your sensors will work with or for any other reason you might come up with...
Materials: 6" of 2"id PVC pipe, 2 end caps, 1 screw on shrader valve.
1. Seal one end of the pipe with a cap.
2. Fit yer sensors into pipe. (I put in some packing material to keep them from bounching around)
3. Drill 1/2" hole into 2nd cap and install valve.
4. Glue 2nd cap to pipe.
5. Inflate to 35psi and place put it somewhere in vehicle. (light and chimes go bye-bye.)
NOTE: Once you are done you will notice that your project looks a little like something that yer local PD will not enjoy comming across
Hope this helps someone other than me!