I can't find anyone who sells them. What bumpstops is everyone using with spacer kits?

Jeepin by al sells a set of urethane bumpstops for the rear. They're for their 4" lift but are cut to fit smaller ones. They attach to the spring perches on the rear axel with a screw through the center. (just make sure the socket for the screw you choose fits the hole through the center of the bumpstop)

_________________
2010 KK Deep Water Blue,OME Liftplus 1",JBA 5.5 UCA ,Dynaflow cat back exhaust, Weathertech VV & mats,Mopar skids,Atthehelm front bumper, Smittybilt XRC 10, Rigid LED's,RL Skink Supersliders,Gecko Safari Basket Detroit Truetrac rear, E-Locker front, G2, Dana 4.10's

I used Zone universal bump stops. They attach the same as Ted explained. They have more surface area to contact and are solid. My old rubber bump stops didn't work well enough to keep 32s from rubbing in the wheel well.

You can make your own with hockey pucks

_________________
Alec
1987 Jeep XJ
The Build Thread
Chincy 2" lift for now
31x10.50r15s
HPD30 front and D44 rear

were do I get these zone units? i read about the pucks but i am to lazy to make them work, its easyier for me to just buy something.

IM useing daystar KU09006BK 13 buck on amazon i trimed the top off its a single piece with a nylon locking nut i did buy brass washers not needed but the nut is not much bigger then the drilled hole just a cheap addon. http://www.amazon.com/Daystar-KU09006BK ... =KU09006BK

_________________

2010 Jeep Liberty Sport 4X4 Natural Green Pearl
Silverstar Headlights,Mopar Hitch,Mopar Tow Hook,Mopar Skids,Mopar Locking Lugs,Mopar Remote Start,Factory Sirius Radio,WeatherTech Digital Floor Mats,JCROffroad Stage 3 Sliders,Hankook DynaPro RF10 LT225/75/16,Diehard Platinum P1,JBA 5.5 UCA,OME HD,