| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| extended rear bumpstops? http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=104&t=74367 |
Page 1 of 1 |
| Author: | crippled [ Sun Mar 03, 2013 4:07 pm ] |
| Post subject: | extended rear bumpstops? |
I can't find anyone who sells them. What bumpstops is everyone using with spacer kits? |
|
| Author: | Ted15 [ Sun Mar 03, 2013 5:32 pm ] |
| Post subject: | Re: extended rear bumpstops? |
Jeepin by al sells a set of urethane bumpstops for the rear. They're for their 4" lift but are cut to fit smaller ones. They attach to the spring perches on the rear axel with a screw through the center. (just make sure the socket for the screw you choose fits the hole through the center of the bumpstop) |
|
| Author: | DirtyKK [ Sun Mar 03, 2013 5:52 pm ] |
| Post subject: | Re: extended rear bumpstops? |
I used Zone universal bump stops. They attach the same as Ted explained. They have more surface area to contact and are solid. My old rubber bump stops didn't work well enough to keep 32s from rubbing in the wheel well. |
|
| Author: | TheBlueKJ [ Sun Mar 03, 2013 6:07 pm ] |
| Post subject: | Re: extended rear bumpstops? |
You can make your own with hockey pucks |
|
| Author: | crippled [ Sun Mar 03, 2013 8:01 pm ] |
| Post subject: | Re: extended rear bumpstops? |
DirtyKK wrote: I used Zone universal bump stops. They attach the same as Ted explained. They have more surface area to contact and are solid. My old rubber bump stops didn't work well enough to keep 32s from rubbing in the wheel well. were do I get these zone units? i read about the pucks but i am to lazy to make them work, its easyier for me to just buy something. |
|
| Author: | teckn9ne [ Sat Mar 09, 2013 11:45 am ] |
| Post subject: | Re: extended rear bumpstops? |
IM useing daystar KU09006BK 13 buck on amazon i trimed the top off its a single piece with a nylon locking nut i did buy brass washers not needed but the nut is not much bigger then the drilled hole just a cheap addon. http://www.amazon.com/Daystar-KU09006BK ... =KU09006BK |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|