| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| Repurposing the buttons normally used for heated seats, etc. http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=104&t=79277 |
Page 1 of 1 |
| Author: | ClayAlex93 [ Thu Jun 05, 2014 1:55 pm ] |
| Post subject: | Repurposing the buttons normally used for heated seats, etc. |
I'm going to be installing a light bar soon and was wanting to make the switch one of the unused switches that is normally for heated seats since I don't have those. Has anyone done this, if so would you mind kind of guiding me through how to do it. |
|
| Author: | Bmxer524 [ Thu Jun 05, 2014 10:56 pm ] |
| Post subject: | Re: Repurposing the buttons normally used for heated seats, |
I don't think it's possible. Last I knew the whole part is a circuit board whether or not you have the buttons there. |
|
| Author: | WhiteRider [ Sun Jun 08, 2014 4:43 am ] |
| Post subject: | Re: Repurposing the buttons normally used for heated seats, |
I have seen that center console bank of switches, moved to the drivers knee panel... Then a custom set of switches put in its place. Only way I could see you using the existing, would be to de-solder the switch (heated seat switch in this case) completely from the board and use it as a dedicated switch for only the light bar circuit. I'd rather have a choice about what kind and where they get put, than go through all the that trouble?! |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|