Good evening

I have a jeep liberty crd kk 2010 diesel uk version 2.8diesel ! I have a check engine problem and engine power loss on uphill after the car runs about 10 minutes. Start Apparently all started when I left the diesel fuel almost over and I arrived at the gas station almost in diesel vapor. So I arrived at the gas station check engine is on.

I completed the diesel tank and left and in the next two days the check engine called and hung up several times until it was on direct

I go to de dealer and I change the fuel filter but the light keep on.

The dealer not tell me the code error dtc and he told me something about a sensor but no name . to they give to me the diagnostic they want 200 usd

What is the best scanner for this car with procedures:

I try to see the error code starting 3 times the ignition but no error apear in the painel just the word done appear.

If somebody have this problem let me know or if know somethig

Thanks
Fabio

Howdy Fabio - Welcome to LOST

might want to repost this over in 'CRD love that torque' - that's the main diesel section

however virtually no KK's or 2010's - they only sold the CRD in the US - 05/06 KJ's

so most answers will reference those.

we do have a few folks that check in from UK - just not as often

I read codes with a Scangauge - not great - it will cause problems if you leave it connected

_________________
2005 CRD
stuff
Skeptic quod gratis asseritur, gratis negatur