LOST JEEPS
http://www.lostjeeps.com/forum/phpBB3/

KJ HITCH TO A KK HITCH
http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=113&t=56818		 Page 1 of 1
Author:  tommudd [ Wed Nov 10, 2010 5:10 pm ]
Post subject:  KJ HITCH TO A KK HITCH
Every since I chopped off the bottom of the bumper I haven't like the way the KJ hitch was so low looking
So after Buggin discovered (by accident) that a MOPAR KK would bolt up without too many modifications I went on the search of one
Found one in Grand Rapids, MI and best part was the guy was traveling through Toledo last evening so dropped it off! :BANANA:
So before
Image
and after, no it doesn't sit lower now just the angle :banghead:
Image
Now time to paint :wink:
Author:  03CDKJ [ Wed Nov 10, 2010 9:20 pm ]
Post subject:  Re: KJ HITCH TO A KK HITCH
Looks sooooo much better! 8)
You're catching me a little bit every day! :mrgreen:
Author:  tommudd [ Wed Nov 10, 2010 9:56 pm ]
Post subject:  Re: KJ HITCH TO A KK HITCH
Catching you...... :ROTFL: other way around
Top of the ball with a 3 inch drop is 22.25
have to go with a 4 inch drop now.
this hitch does sit the ball back away from the tire though
Image
Author:  Megalos [ Wed Nov 10, 2010 10:10 pm ]
Post subject:  Re: KJ HITCH TO A KK HITCH
tommudd wrote:
Catching you...... :ROTFL: other way around


I think Chris means that you're so far ahead you're getting ready to lap him.

Don't know what I'm talking about though, I'm so far behind I might be ahead myself.

By the way...what kind of mods does the kk hitch need to fit the kj?
Author:  tommudd [ Wed Nov 10, 2010 10:27 pm ]
Post subject:  Re: KJ HITCH TO A KK HITCH
There is a pinch weld at the rear that has to be cut and bent over, an area of maybe 3 inches wide on each side, ( got to use power tools for install :twisted: )
then the plastic "stuff" behind the bumper, more of it has to be cut ( than what I had cut off originally)
So not hard but holding up a 50 lb Kilby gas tank skid along with balancing the hitch made for an interesting evening, finally put the Kilby on jack stands up tight and then jacked the hitch into place. Got smart!!!
Oh and on the left side I'll need to add some metal to it for mounting, only two of the three holes line up, right side is fine!
Nice thing about the Kilby you can jack the whole back end up just using it!

Offered Chris 50 bucks to come and help me but....... NOOOOO :furious: :banghead:


And you are right I am about to lap him and have him One Lap Down!!!! :pepper: :BANANA: :JEEPIN:
Author:  teckman02 [ Wed Nov 10, 2010 11:40 pm ]
Post subject:  Re: KJ HITCH TO A KK HITCH
tom if i was closer to Toledo i would have came to help and you would not even have to pay me 50 bucks
Author:  JeepinJarhead03 [ Wed Nov 10, 2010 11:50 pm ]
Post subject:  Re: KJ HITCH TO A KK HITCH
looks good :)

time to move the plate to the spare tire :P

sissy ol spare tire cover ;) smatter.. it gunna get dirty? hehe

...

yeah i knowwww ice on the spare tire lug nuts is a pain in the winter :P
Author:  tommudd [ Thu Nov 11, 2010 12:38 am ]
Post subject:  Re: KJ HITCH TO A KK HITCH
The spare tire cover was the "only " thing my wife ever bought for or really wanted on the KJ. She liked that cover and wanted one on it.
SO....I sort of keep it on for her.
Plus that wheel is messed up by the PO, lots of rock scratches on it.
Well it will have them until here in a , ................................
wait can't tell whats next for the Heep
Author:  JeepinJarhead03 [ Thu Nov 11, 2010 2:32 am ]
Post subject:  Re: KJ HITCH TO A KK HITCH
understandable :)
Author:  blackwidowkj06 [ Fri Nov 12, 2010 12:16 am ]
Post subject:  Re: KJ HITCH TO A KK HITCH
looks good
Author:  BugginKJ [ Sun Nov 14, 2010 3:51 pm ]
Post subject:  Re: KJ HITCH TO A KK HITCH
Oh come on Tom nothing we do is by "accident" :ROTFL: Looks so much better! :twisted: :JEEPIN:
Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/