This is what I bought.
Package Includes:
Cobra 75 WX ST CB Radio
3' or 4' Wilson FLEX CB Antenna
18' cable
Mounting Options:
3-Way Vertical Surface & Mirror Kit
or Jeep Wrangler Hood Kit
or Teraflex CB Mount Kit
or Universal Hood & Channel Kit
Compact External Speaker
Standard SWR Meter and Jumper Cable
First I notched out the left tail light base to access the body.
Then I drilled holes into the body panel.
A little Form-a-Gasket for sealant.
The antenna mount had to be bent slightly to miss the edge of the lens.
The antenna mount installed.
The cable was run from the mount to behind the right bumper end cap and into the well below the rear gate lip.
A drill mark was made at the thinnest part of the gate lip.
The cable passed through the hole into the cabin.
A rubber grommet from a Pep Boys assortment was installed on the edge of the hole around the cable.
The cable was run to the drivers side in existing factory clips and behind trim panels to the front.
The junction/control box was installed on the plastic knee box cross bar with sheet metal screws and grounded with a 16 awg twisted copper wire to the steering column mount. The power wires were sent through the plastic grommet on the left firewall below the wire bundle that passes into the engine compartment.
The mic cable plate that was provided was attached to the reader port after drilling a hole in the corner of the plate.
The mic hanger was installed on the dash where the display could be seen while driving.
The hand-held installed.
View from the rear.
View from the side.
The rear door clears the antenna by 1/4 - 3/8 inch
The rear glass clears the antenna by 1/2 - 5/8 inch.
Hope this was helpfull.
Sorry for the previous posts....I'm still learning.