LOST JEEPS
http://www.lostjeeps.com/forum/phpBB3/

MAY 24th! JOHNSON VALLEY OHV! BE THERE!
http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=21&t=30451
Page 1 of 1

Author:  JJsTJ [ Wed Mar 12, 2008 8:39 am ]
Post subject:  MAY 24th! JOHNSON VALLEY OHV! BE THERE!

We are going to do a tour of the Johnson Valley OHV area on May 24th.
Our tour guide will be Mike K. from the Bear Valley 4 Wheelers club. (Great guy, several of us have wheeled w/ him before)

I rate this run as moderate, with the sand dunes posing the most challenge decause of the deep sand. We start at Camp Rock Rd. at Cougar Buttes, run the ridge over to soggy dry lake the on over to means dry lake to the Hammers trail head then a large loop northward back around to Camp Rock Rd. to Hwy 247.

Highlights are:
Hugh granite rocks at Cougar Buttes
Cross 3-4 dry lakes.
Check out the Hammer trails. (on foot)
Large sand dunes
Indian petroglyphs
Cinder cone mine. (active)
Old windmill and water trough
Maybe an old mine site or two

This usually takes all day to do.

We are not doing the actual Hammer trails, just checking them out unless you want to play of course. As mentioned above, this is a moderate run so you will need a lift, rock rails, recovery points, recovery gear, sense of humor, big smile, and be ready for Fun! I don't expect a lot of rock crawling but there will probably be enough to make it fun.


SATURDAY, MAY 24th, 2008
Be there or be Square!

(meeting spot info coming soon)

Author:  JJsTJ [ Wed Apr 09, 2008 9:22 am ]
Post subject: 

BTT

Author:  yazhi [ Wed Apr 09, 2008 1:28 pm ]
Post subject: 

Not to be the gloom and doom.....but that's not going to be a tour.....that's going to be a circus!!!! Johnson Valley over Memorial Day weekend, that's down right scarey.
But I do have it on the calendar :)

Author:  CaKJFreedom [ Wed Apr 09, 2008 2:05 pm ]
Post subject: 

Quote:
The eastern boundary is shared with the Twenty-nine Palms Marine Air-Ground Combat Center. DO NOT enter this area.


Yeah, that's would put a damper on the day wouldn't it?

Author:  JJsTJ [ Wed Apr 09, 2008 2:26 pm ]
Post subject: 

Better see it now in case the Marines decide they need it more than we do and take it away from us. :?

Author:  hoku5 [ Wed Apr 09, 2008 5:09 pm ]
Post subject:  May 24th Johnson valley OHV

Pencil me in going to try a make it.

Author:  JJsTJ [ Tue Apr 29, 2008 7:31 pm ]
Post subject:  Re: May 24th Johnson valley OHV

hoku5 wrote:
Pencil me in going to try a make it.
Sorry Nolan, I only have a pen so I INKED you in!! :wink:

Anyone else?? This is going to be a great run and in a very neat area that we might lose someday.

Author:  Edvalencia [ Tue Apr 29, 2008 8:10 pm ]
Post subject: 

IN :D

Author:  hoku5 [ Wed Apr 30, 2008 11:01 pm ]
Post subject:  May 24th Johnson Valley

OK JJ I'll see you on the 24th.

Author:  JJsTJ [ Wed Apr 30, 2008 11:21 pm ]
Post subject:  Re: May 24th Johnson Valley

hoku5 wrote:
OK JJ I'll see you on the 24th.
Sweet! I knew my Pen would work! :D

Author:  JJsTJ [ Wed May 07, 2008 1:54 pm ]
Post subject: 

Btt 8)

Author:  JJsTJ [ Mon May 19, 2008 11:09 am ]
Post subject: 

HELLO! Meeting for this run at 0900 at the 76 station in Lucerne where the 18 & 247 meet.

LUCERNE VALLEY MAP
PLMK if you have any questions or comments.
THanks, John

Author:  Edvalencia [ Mon May 19, 2008 11:44 am ]
Post subject: 

While trying to screw my tranny skid back on, I killed two nutzerts. Now I have to drill through the crossmember. Anyone have a recommendation on what type of bolts to use?

Otherwise, I'm ready to go :D

Author:  JJsTJ [ Mon May 19, 2008 12:30 pm ]
Post subject: 

Edvalencia wrote:
While trying to screw my tranny skid back on, I killed two nutzerts. Now I have to drill through the crossmember. Anyone have a recommendation on what type of bolts to use?

Otherwise, I'm ready to go :D


I use carriage bolts so the head is rounded and can't snag on stuff. Drag it over this week and we can get you fixed up, I am sure I have some bolts long enough.

Author:  Edvalencia [ Mon May 19, 2008 1:48 pm ]
Post subject: 

I'll call ya!

Author:  lilblkblt04 [ Tue May 20, 2008 1:38 pm ]
Post subject: 

I wish it was closer to my house or we would make the drive up there. Its 2 hours and 45 minutes according to MapQuest...too long for one day.

Have fun on this trip!!

Ryan

Author:  hoku5 [ Fri May 23, 2008 4:17 am ]
Post subject:  MAY24 JOHNSON VALLEY OHV

Sorry but can't make this event. I havn't had the time to change my steering rack and don't want to break down while wheeling. I have all the parts just need the time. I'm shooting for BB on May 31st. Have fun and be safe.

Author:  JJsTJ [ Fri May 23, 2008 8:42 am ]
Post subject:  Re: MAY24 JOHNSON VALLEY OHV

hoku5 wrote:
Sorry but can't make this event. I havn't had the time to change my steering rack and don't want to break down while wheeling. I have all the parts just need the time. I'm shooting for BB on May 31st. Have fun and be safe.


Nolan, while you are capable w/ a set of hand tools :wink: , hit up TJKJ2002 for info on how he did the job Really fast in Moab. He knows some short cuts that will save you a bunch of time. (unless you already know them)

We will miss you on the trail!!

Author:  hoku5 [ Sat May 24, 2008 6:40 pm ]
Post subject:  Johnson Valley OHV

Yes I have made a copy on his tips on replacing the steering rack. Thanks

Author:  JJsTJ [ Sun May 25, 2008 11:58 am ]
Post subject: 

Well, we really need to get back out to the JV area in the future. It is a huge area to explore and looking at the areas that Mike wanted to take us looks like it would be a lot of fun and cool areas to explore. Since we only had 3 well set up rigs we ran a different, more difficult area (which would be great fun in a KJ for sure)
See the trip report for where we ended up for pics and info. Sorry some couldn't make it and hope to see more at the next event.

Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/