Suspension swap help needed in Denver
Page 1 of 1

Author:  shelbydz [ Fri Jun 08, 2012 5:29 pm ]
Post subject:  Suspension swap help needed in Denver

Hey guys,

Is any one available 6/16 to help me put the OME stuff on my CRD? Its been a while since I've done a full suspension swap. I think I have all the tools, but am prolly missing the larger sockets for the axels and struts.

We're actually moving at the end of this month. I was laid off here jobs opened up there. Lol. Pm me if you are willing. I'll buy some beer and lunch :-)


Author:  Ya_Veo [ Sun Jun 10, 2012 2:38 pm ]
Post subject:  Re: Suspension swap help needed in Denver

If I was in Colorado I would invite you down to the springs and help you out. I did my lift finally about three weeks ago and it's been great.

The biggest problems I come across was my upper control. The screw on it broke away(it would just spin in place) and I couldn't loosen it or tighten it until I got an impact wrench. Good luck! And sorry I can't help.

Author:  shelbydz [ Sun Jun 10, 2012 9:10 pm ]
Post subject:  Re: Suspension swap help needed in Denver

No worries. I called a buddy of mine and he's going to come over. I should be okay.

I'm not planning to change out the strut mounts (per Rocky Road's advice). Is it possible that I would need to? I don't have a lot of available down time.


Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group