LOST JEEPS
http://www.lostjeeps.com/forum/phpBB3/

CV Boot Adjustment with Frankenlift
http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=3&t=10395		 Page 1 of 1
Author:  Wasatch15 [ Thu Jul 13, 2006 7:22 am ]
Post subject:  CV Boot Adjustment with Frankenlift
Have those of you that have the Frankenlift installed on your Libby adjusted the CV boots out further so the bellows aren't touching, all squished up against each other? If so, after adjustment, does the boot stay where you placed it even though there isn't a groove machined in the CV halfshaft where it is now installed?

Thanks,
Ron
Author:  JJsTJ [ Thu Jul 13, 2006 10:02 am ]
Post subject: 
I have about 25K miles (on my 03) on my Frankenlift w/out moving the boots and no problems w/ them. We will see how it works out on my 04 since swapping the FL to it.
Author:  Se7enLC [ Thu Jul 13, 2006 11:37 am ]
Post subject: 
I had a CV boot replaced after the lift was installed, and it definitely looked a lot better than before, now that all the bellows aren't squished. I considered having them re-do the other side, too, but seeing as the factory clamp is welded, they'd probably have to just replace the whole thing anyway, I may as well wait until it fails.
Author:  fdezone [ Sat Jul 15, 2006 11:36 am ]
Post subject: 
My passenger side CV boot high-ordered.
Author:  Jeepjeepster [ Sat Jul 15, 2006 12:16 pm ]
Post subject: 
fdezone wrote:
My passenser side CV boot high ordered.


I said that really slow and it still makes no sense to me. :?:
Author:  fdezone [ Sat Jul 15, 2006 4:51 pm ]
Post subject: 
It high-ordered, aka, high-order detonation, blew up, disintegrated, etc. Or, I tore my CV boot!
Author:  JFortier777 [ Sun Jul 23, 2006 2:42 am ]
Post subject: 
fdezone wrote:
It high-ordered, aka, high-order detonation, blew up, disintegrated, etc. Or, I tore my CV boot!



AH! The horror!
Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/