| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| Trim Removal For Skink Sliders http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=3&t=13890 |
Page 1 of 1 |
| Author: | desertkj [ Sat Oct 28, 2006 11:47 am ] |
| Post subject: | Trim Removal For Skink Sliders |
OK, I'm getting ready to start installing my Super Skink Sliders. However, there's a piece of plastic trim along the bottom of the rocker panel that looks like it needs to come off. I dont see any screws to take it off, so does it just pop off? I'd post pics, but my camera is dead right now. |
|
| Author: | unixxx [ Sat Oct 28, 2006 11:59 am ] |
| Post subject: | |
There should be a supplement to the installation manual that comes with the sliders. Essentially, you pry off the bottom clips with a hammer and then trim out any places where the two pieces of trim overlap. This way the trim will lay flat and provide more clearance for the sliders. I think I might just cut a strip out along the entire piece of trim so I can push up the pinch seam mount as far as possible. |
|
| Author: | desertkj [ Sat Oct 28, 2006 12:01 pm ] |
| Post subject: | |
I think yours might be a little different though as I have the 02 and you have the newer design. I believe Jeep changed that design a little bit. I'm thinking that becuase I dont see a supplement regarding that. |
|
| Author: | Skyjump136 [ Sat Oct 28, 2006 1:34 pm ] |
| Post subject: | |
Just PM RockLizard, or TokyoJoe would probably know too. |
|
| Author: | desertkj [ Sat Oct 28, 2006 2:44 pm ] |
| Post subject: | |
Yep. I got it off. Just pops off. Why do companies insist on going gung-ho with these plastic clippy thingies? |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|