LOST JEEPS
http://www.lostjeeps.com/forum/phpBB3/

Transmission skid plate hardware
http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=3&t=18994		 Page 1 of 1
Author:  65thKJ [ Mon Mar 26, 2007 7:30 pm ]
Post subject:  Transmission skid plate hardware
I just picked up my 4 skid plates and I was putting them on today when I realized that I need 2 more nutzerts and bolts. My tranny skid plate didn't come w/ any hardware at all. I thought that would be OK cuz it would overlap the transfer case and engine ones. However it looks like i neeed 2 nutzertz and nuts for the back since it doesn't overlap w/ the transfer case one. Has anyone ordered the tranny skid? Did it come w/ any hardware?
Author:  BVCRD [ Tue Mar 27, 2007 8:46 am ]
Post subject: 
I was shorted one. I used the flare tool that came with it and got a bolt and washer at the hardware store.
Author:  Jeepjeepster [ Tue Mar 27, 2007 1:47 pm ]
Post subject: 
Just drill a hole through the cross memeber and put a bolt through it. I believe I used 2.5in Grade 8 1/4in bolts. :)
Author:  65thKJ [ Tue Mar 27, 2007 4:42 pm ]
Post subject: 
I don't want to drill it. I just called the dealership. They ordered a new skid plate and it came w/ the hardware so they'll give it to me.
Author:  tommudd [ Tue Mar 27, 2007 5:15 pm ]
Post subject: 
Should of went ahead and drilled it , would of been stronger and I think a vehicle is never really yours until youve drilled a few holes in it somewhere! :lol:

Tom
Author:  65thKJ [ Tue Mar 27, 2007 8:53 pm ]
Post subject: 
tommudd wrote:
Should of went ahead and drilled it , would of been stronger and I think a vehicle is never really yours until youve drilled a few holes in it somewhere! :lol:

Tom


Good point
Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/