Anyone have a materials list, mainly tools, for doing a coil lift? Looking for wrench/socket sizes .... thanks in advance

_________________
Pre-Lowered 02 Liberty
2.5" Rustys Coil w/ Ranchos in the rear.
ARB, OME927's, 1/4 strut plate and Als Gen 4.5 Uppers in the front.
Flowmaster Super 40 Series (GONE, SO QUIET!)
245/75/16 Kumho KL-78 w/ Spidertraxxxxx
Ripped out the plastic inner wheel liners
Herculined ALLLL over.....

Here's what I got when I asked

http://www.lostjeeps.com/forum/phpBB3/vie ... ight=tools

_________________
Chris

2005 Renegade
Frankenlift
245/75/16 Goodyear MT/Rs

I just competed a coil lift. Here are the tools I used.

1. 3 ton hydrolic Jack (must have)
2. 2 Jack stands
3. 1/2 socket set with breaker bar. Standard upto 13/16 and Metric upto 18
4. Sockets sizes 10, 12, 15, 18, 11/16, 3/4, 13/16.
5. Ratchet Strap
6. Hammer
7. Flat head screw driver
8. Phillips head screw driver
9. Adjustable wrench
10. An extra pair of hands

I hope this helps. I did the lift on a CRD but it should be pretty close. I took me about three hours a side for the front and rear took about 1 hour total. There is a really good "How To" on the http://www.jeepkj.com. Good Luck.

_________________
2005 CRD , Moab Rims, 245/75/16 Goodyear M/T
RL rear bumper, TMJ Front bumper, Frankenlinft,
*TOTALED*

1985 Mitsubishi Pickup SP 2.3 Turbo Diesel Watercooled turbo,4D56 ported head,
12" Suspension Lift with JK Rubicon axles, Elockers, 5.13's, Fox coilovers, Atlas 5.0, Rock Lizard supersliders

1996 Lexus LX450 -locked and lifted-