So I finally got all the parts in to replace my horrible Rusty's lift and will be working on it this week sometime.

Here's what I got:

OME 927's
OME NS131
Boiler's Shims
Teraflex Extended Bumpstops
Conduit Nuts

I've been reading all the how to's on installing the lift but I was just wondering how you go about removing the stock front bumpstops and putting the Teraflex ones in? It might by super simple but I'm sure you guys have some good advice and tricks to making it easy.

Thanks for the help in advanced! Also any other final tricks for installing the lift?

_________________
04 Liberty Sport 4x4;
3.7L V-6
Amsoil Filter
Rusty's 2.5in Lift
Lund Air Deflector
Hella 500 Series Lights (6)
Sirius Sat. Radio; Garmin GPS System
Amer. Racing ATX Chamber w/Teflon; Goodyear Wrangler Silent Armor 265/70/16

I took pliers and a screw driver and pulled/ pried the old ones out.
New ones lube them up some and start the back side in, take a 2X4 or some have used a shovel and push it up in.
Pretty simple although I have had a couple of them fight me some

_________________
MUDD'S MOTORSPORT'S We do IFS lift installs ,
03 OVERLAND EDITION /Kilby-Skidrow-Mopar-4XGuard skids/ 2.5 inch TOTAL CONTROL JBA coilovers -JBA Arms/MOABS-31 FALKEN WILDPEAK AT3W / 4.10's etc, 04 Kilimanjaro Edition loaded, plus 05 KJ limited

yea the 2x4 idea sounds good, i broke a sweat gettin mine in

_________________
'02 Liberty Limited 4x4
-Selec Trac
-MTR's 245/75-16
-Rock Lizard Super Skink Sliders(custom)
-Engine skid, Skidrow Transmission skid
-4" Lift - JBA 4.5 Gen A-arms
Installed@165,920k
Pilot lights on cowl
Engine replacement at 175k

Out is easy. In can be a bugger...... I used a 4x4 against the tire to push them into place after greasing them up.

_________________
99 TJ
71 C101
04 KJ
03 SFA KJ Sport
LOST JEEPS So-Cal

i froze mine

_________________
Steve
2018 RAM 1500 Rebel
2003 KJ
Mods:Exterior: Frankenlift + 2 extra rear iso, JBA UCAs, ARB Bumper w/XRC8, Safari Snorkel, 265/75/16 AT, Mopar Skids, Boulderbars, RL Gecko Sport Rack
Interior: Infinity Reference speakers, 12" Alpine Type R Sub, Alpine radio, Gauge Pods (Oil, Volts), Cobra Cb, All J Interior Rack

froze mine too but that didnt seem to do jack

_________________
'02 Liberty Limited 4x4
-Selec Trac
-MTR's 245/75-16
-Rock Lizard Super Skink Sliders(custom)
-Engine skid, Skidrow Transmission skid
-4" Lift - JBA 4.5 Gen A-arms
Installed@165,920k
Pilot lights on cowl
Engine replacement at 175k

I just pushed mine in..
I'm really not that strong, lol.

(Actually I've installed them twice, {to cut a notch in them the second time})

_________________
-dbk
SOLD2007 6 Speed - Projector Retrofit -Custom LED Tail Lights - Lights on Cowl & 130w 8" ProComps - Full Skids-RockLizard Super Skink Sliders-Front Hitch
Frankenlifted-Al's A-Arms-Goodyear Duractracs 31x10.5R15x7 Cragar D Window 4"bs-Cobra 75WXST - 4' Firestick
4.10s sitting in a box - 3
Sold-1988 Suzuki Samurai
2002 Jeep TJ

mine pushed in fairly easy with some dish soap

Try spray silicon.

Same stuff you use to keep the extra upper rear isolators from squeaking.

Helps preserve the rubber and makes it easier to insert in the slot.

_________________
Colin
LOST#85291
"Blue Bunny"
04 KJ Sport 3.7L AT 4x4
Steel IFS/DL&DTT/4.10s/Tow Pkg/Mopar-Rusty's-Skid Row skids&sliders/OME struts&springs/Rancho shocks/Terraflex bumpstops/Landy FRH/Gen Steel/Grabber AT2s/Spidertrax/Rockcrusher/Hella/Smittybilt XRC8/Bulldog wiring/NAPA brakes/JBA UCAs&spacers/Deka Intimidator

Did mine like this:

viewtopic.php?p=421904#p421904

_________________
2007 Light Khaki 4x2 Sport
- Debadged - LTT CAI with Amsoil Filter - JVC HD Radio - Infinity BassLink
- Iggee Seat Covers - Black Moabs - 265/75-16 Cooper Discoverer ATP - 4.10's
- DIY Franky sitting at 23.75" - Al's 4.5 UCAs - Trimmed F&R Bumpers
- Removed Rear Sway Bar - Removed Rear Vibration Damper
- 75k miles so far...

I was able to get my old ones out, & the new ones in by hand (bit of dish soap), but on my wife's I had to use the shovel technique to get them in.

_________________
-------------------------------------------------------
http://www.cardomain.com/ride/2434197
2002 Liberty Renegade
-OME 927-Rancho RSX 17505-3 Ring Clevis-JBA UCA-Teraflex Bump Stop
-JBA-LIB25R Rear Coil-2 Upper/Lower Iso-Skyjacker H7088 Shocks-3 Hockey Puck Bump Stops
-Powerslot Rotors-Moab Rims-BFG TA/KO 265-75-R16
-ARB Bumper-Rock Rails
-Super 44 Exhaust
+ Some More Crap