LOST JEEPS
http://www.lostjeeps.com/forum/phpBB3/

lower control arms
http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=3&t=2117		 Page 1 of 1
Author:  vxla [ Thu Sep 22, 2005 12:23 pm ]
Post subject:  lower control arms
anyone replaced their lower control arms? i seem to have bent the left one slightly <grin> after jeepstock last week. the rocks didn't have enough peanut butter goo to smooth my grinding :)
Author:  uvalax236 [ Thu Sep 22, 2005 2:48 pm ]
Post subject: 
Is it still driveable? Are you willing to maby sell it to me and i'll pay shipping to 23229? Let me know!
Author:  vxla [ Thu Sep 22, 2005 2:59 pm ]
Post subject: 
huh? it's still drivable. why would i want to sell it? :) you dont want it, too many dents and dings.

ill find a lca somewhere and replace it if it gets bad, but right now it drives fine.
Author:  Guyute1210 [ Thu Sep 22, 2005 5:16 pm ]
Post subject: 
vxla wrote:
huh? it's still drivable. why would i want to sell it? :) you dont want it, too many dents and dings.

ill find a lca somewhere and replace it if it gets bad, but right now it drives fine.

You missed another conversation of his...he was asking b/c if you were going to replace it, he would need it for testing purposes.
Author:  uvalax236 [ Fri Sep 23, 2005 12:23 am ]
Post subject: 
Yup Yup! Sorry I didnt state that. If you do happen to get a new one then let me know because I would love to get my grubbly little fingers on some Upper and Lower CA's.
Author:  skrracing [ Fri Sep 23, 2005 12:44 am ]
Post subject: 
I have replaced the uppers on mine and a few others. I think I have an old one still around.

We have also replaced the lowers on a KJ out here but there were bent very bad. Sorry Wally for bring it up. Hey It was still a fun day right?

The lowers are a very heavy duty piece and they are seeing a lot of force...Just besure you have this tested before you install a new test piece on a KJ. I work with all kinds of test labs if you need help with this.

Again...the lower control arm see some very high loads...

The parts are kind of heavy are you up for the shipping. I thought the uppers were already done by someone. Jeepin Al? Am I all mixed up? later...Clint
Author:  vxla [ Fri Sep 23, 2005 9:54 am ]
Post subject: 
Yea I think Al did the uppers. I was just thinking about finding some lowers somewhere and swapping them out.
Author:  dbltrbl [ Tue Oct 04, 2005 2:02 pm ]
Post subject: 
i replaced both lower front arms when doing accident repair, both were bent and cracked badly, even they are cast steel they seem to bend.
Author:  kevh [ Tue Oct 04, 2005 2:53 pm ]
Post subject: 
lsightly longer lowers for the rear would be nice to recenter the wheel/tire in the fenderwell
Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/