| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| KJ's 3.5 X Factor Lift from Rock Krawler http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=3&t=21491 |
Page 1 of 1 |
| Author: | mjlocker [ Sun Jun 10, 2007 1:56 pm ] |
| Post subject: | KJ's 3.5 X Factor Lift from Rock Krawler |
I would appercaite any comments from any one that has installed the 3.5 X factor lift on a kj, Rockfathers has stated in there suspension notes that lifts over 2.5" will cause front axle bind, and wouldn't recommend a 3" lift on a kj. |
|
| Author: | raceinfan [ Sun Jun 10, 2007 2:05 pm ] |
| Post subject: | |
anything over 3 inch is asking for trouble unless you do a solid front axel practiculy all members here run 2.5 or the franken lift which will give you a little over that but not much alot of bad water towards Rock Krawler with us KJ owners |
|
| Author: | Dje Ryu [ Sun Jun 10, 2007 2:15 pm ] |
| Post subject: | |
Be careful what you believe on rocky-road's website, too. The part about 3" lifts is true but, there is an awful lot of misinformation on that site, also. |
|
| Author: | Donnie [ Sun Jun 10, 2007 2:54 pm ] |
| Post subject: | |
Technically, I belive you could get away with it for on-road driving. If you going to wheel it stress welds, joints and cv's i doubt it. |
|
| Author: | DarbyWalters [ Sun Jun 10, 2007 4:24 pm ] |
| Post subject: | |
I just have to say stay away from ROCKKRAWLERS stuff when it comes to the Jeep Liberty. They do not test properly and will blame any problems on customer installation. The were selling that lift for the CRDs and never fitted one. The CRDs have the front differential lower and to the drivers side...they finally took the application off the website after a member jumped thru hoops trying to get his $$$ back. |
|
| Author: | Tokyojoe [ Sun Jun 10, 2007 5:25 pm ] |
| Post subject: | |
You may lose your Warranty on your KJ with a lift over 3". My dealer said they have no problems with 2.5" lifts, but Jeep will not accept problems with a KJ over 3" (that have any relation to the problem). |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|