| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| poly spacers and strut plates http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=3&t=21638 |
Page 1 of 1 |
| Author: | Freshmud [ Thu Jun 14, 2007 2:11 pm ] |
| Post subject: | poly spacers and strut plates |
im hoping to get the rustys lift soon, should i be worried about getting the poly spacers and strut plates while im ordering my lift, also what are they for |
|
| Author: | myjeepwalks [ Fri Jun 15, 2007 9:13 pm ] |
| Post subject: | |
I need to get one or the other. I think it would be impossible to get those poly spacers in there without using a wall mounted spring compressor. I had a hell of a time just getting the rusty's springs compressed enough to get the top strut plate on. One of these days i'm gonna get those strut plates for the front to level it out since it put an extra isolator in the rear. |
|
| Author: | spencevans [ Sat Jun 16, 2007 1:18 am ] |
| Post subject: | Re: poly spacers and strut plates |
Freshmud wrote: im hoping to get the rustys lift soon, should i be worried about getting the poly spacers and strut plates while im ordering my lift, also what are they for
If you want a RL rear bumper then you will want the rear poly spacers. Hint Hint. 
|
|
| Author: | myjeepwalks [ Sun Jun 17, 2007 8:20 pm ] |
| Post subject: | Re: poly spacers and strut plates |
spencevans wrote: Freshmud wrote: im hoping to get the rustys lift soon, should i be worried about getting the poly spacers and strut plates while im ordering my lift, also what are they for If you want a RL rear bumper then you will want the rear poly spacers. Hint Hint. I think he's talking about the front poly spacers rusty sells. The ones that go between the front strut and the spring. |
|
| Author: | Freshmud [ Sun Jun 17, 2007 8:22 pm ] |
| Post subject: | |
ok well if i dont have that bumper on now should i get one or the other for a little extra height or not |
|
| Author: | myjeepwalks [ Sun Jun 17, 2007 8:30 pm ] |
| Post subject: | |
Freshmud wrote: ok well if i dont have that bumper on now should i get one or the other for a little extra height or not
To tell you the truth i dont' know. I have a 3 ring clevis lift with the rusty's lift and also one extra isolator in the rear. It sits pretty close to level. The front is a little lower but i think if i put those strut plates in it might level it perfect or make the front sit a little higher. Right now i've pretty much lost interest in modding the kj. Too busy trying to sell my stupid condo and looking for a house. You can try the plates they're easy to take out if you don't like them compared to those poly spacers where you would have to disassemble the entire strut again. What a pita that is. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|