LOST JEEPS
http://www.lostjeeps.com/forum/phpBB3/

Clevis lift?
http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=3&t=28676		 Page 1 of 1
Author:  XC204 [ Fri Jan 18, 2008 2:59 pm ]
Post subject:  Clevis lift?
So the new KK has a one inch or so clevis and appears to have same strut size how about the A arm end could this be the ultimate clevis lift?
Author:  Jeepjeepster [ Fri Jan 18, 2008 4:03 pm ]
Post subject: 
Not so sure what youre getting at.

You can not get lift with a different upper A-Arm.
Author:  XC204 [ Fri Jan 18, 2008 4:33 pm ]
Post subject: 
The clevis could be put in if both ends are the same as KJ just a longer clevis ?
Author:  tjkj2002 [ Fri Jan 18, 2008 5:09 pm ]
Post subject: 
The KK clevis is 1" longer then the KJ's,from the measurements it should fit on the KJ with no problems.It'll give 2" of lift on a KJ all by itself.
Author:  XC204 [ Fri Jan 18, 2008 5:33 pm ]
Post subject: 
Thats what I was thinking.
Author:  WoodysKJ [ Fri Jan 18, 2008 6:02 pm ]
Post subject: 
tjkj2002 wrote:
The KK clevis is 1" longer then the KJ's,from the measurements it should fit on the KJ with no problems.It'll give 2" of lift on a KJ all by itself.


So they are a direct swap? 08 KK clevis' into a KJ?

gains an additional inch possibility from the longer clevis?
Author:  tjkj2002 [ Fri Jan 18, 2008 9:11 pm ]
Post subject: 
WoodysKJ wrote:
tjkj2002 wrote:
The KK clevis is 1" longer then the KJ's,from the measurements it should fit on the KJ with no problems.It'll give 2" of lift on a KJ all by itself.


So they are a direct swap? 08 KK clevis' into a KJ?

gains an additional inch possibility from the longer clevis?
You'll gain 2" of lift from the KK clevis alone,remember to times by 2 for the amount,3/8" clevis lift gains you 3/4" of lift and so on from the placement of the clevis on the LCA.
Author:  dloc_jeep_KJ [ Sat Jan 19, 2008 12:14 am ]
Post subject: 
thats a good idea actually then. how much would this cost to get the KK clevis?? would it mess anything up though?? ill be following this to see how it turns out. heck i might actually try it if everyone thinks it will work with out having any major problems.
Author:  tommudd [ Sat Jan 19, 2008 3:42 pm ]
Post subject: 
So has anyone went as far as to see if the KKs clevis are available from a dealer?
Author:  XC204 [ Mon Jan 21, 2008 6:32 pm ]
Post subject: 
Need some one with a lunch box in Toledo !
Author:  tommudd [ Mon Jan 21, 2008 6:34 pm ]
Post subject: 
XC204 wrote:
Need some one with a lunch box in Toledo !


Tried that, trust me too many guards checking everything :lol: :lol: :lol: :lol: :lol:
Author:  dloc_jeep_KJ [ Mon Jan 21, 2008 6:39 pm ]
Post subject: 
would this over compress ur spring?? could any harm actually be done by this?? and could u use OME HDs and actually get them on? that was a little tight to get ack in with my rustys lift but im sure it could be done. im still up for trying it though.
Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/