LOST JEEPS
http://www.lostjeeps.com/forum/phpBB3/

front spacer measurement
http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=3&t=29367		 Page 1 of 1
Author:  jbjeeper [ Sun Feb 10, 2008 11:22 am ]
Post subject:  front spacer measurement
I want built a lift kit for a frien and i have to know the height off the over the top front spacer like the rocky-road outfitters 2.5" kit?

thanks
Author:  KY Liberty [ Sun Feb 10, 2008 12:30 pm ]
Post subject: 
Going with that lift is a good way to lose that friend.
Author:  tommudd [ Sun Feb 10, 2008 12:38 pm ]
Post subject: 
Good way to save your friend a lot of money when you install it, also a good way for your friend to spend a lot of money replacing upper control arms, struts etc in the very near future. In other words dont even think of going that route. If he wants a lift, do it right the first time and be done with it, that way you will still have a friend in the future!

Tom
Author:  jbjeeper [ Sun Feb 10, 2008 1:34 pm ]
Post subject: 
What it change to the upper control arm to lift by a spacer or a longer coil?
Author:  Jeepjeepster [ Sun Feb 10, 2008 4:51 pm ]
Post subject: 
What they are saying jbjeeper is that lift is no good. It breaks suspension parts.

The best route is to replace the coil springs to get the lift you want. Rustys is a all around great lift kit.

If you do not want to spend that kind of money, the Daystar spacer lift is a good spacer lift that will not hurt the suspension parts like the Rocky Road Over the Top lift does. :)
Author:  KJ04 [ Mon Feb 11, 2008 12:17 pm ]
Post subject: 
I thought that the OTT spacer problems were laid to rest by using the Tera Flex 4" extended front bump stops with it. :shock:
http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?t=28552
Author:  tommudd [ Mon Feb 11, 2008 12:50 pm ]
Post subject: 
well yes if they use the bumpstop then it would or should be alright

I have a set (OTT) that came with my used ARB, I been using them for door stops, Never tried to sell them do to not feeling right about taking someones money for something that didnt work well. Did start to cut one up over the weekend for a special project on mine though :wink:
Author:  dloc_jeep_KJ [ Mon Feb 11, 2008 1:27 pm ]
Post subject: 
cut one up hmm. didnt think about that please tell more or PM me what u are doing. i have a OTT spacer kit from Rusty's. i was going to sell it and it is in the for sale section. i guess i could cut it up though.
Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/