| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| Skid plate bolt size? http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=3&t=32359 |
Page 1 of 1 |
| Author: | Jeep4me99 [ Fri May 09, 2008 6:18 pm ] |
| Post subject: | Skid plate bolt size? |
What size are the skid plate bolts that go into the front cross member? |
|
| Author: | Guest [ Fri May 09, 2008 6:49 pm ] |
| Post subject: | |
15mm |
|
| Author: | Jeep4me99 [ Fri May 09, 2008 7:05 pm ] |
| Post subject: | |
thanks... bolt diameter, length thread pitch is what i'm really looking for. |
|
| Author: | Guest [ Fri May 09, 2008 7:34 pm ] |
| Post subject: | |
going from memory (I just had them out a couple days ago) they look like 12x1.25 or 12x1.5, about 30mm long. |
|
| Author: | tjkj2002 [ Fri May 09, 2008 8:31 pm ] |
| Post subject: | Re: Skid plate bolt size? |
Jeep4me99 wrote: What size are the skid plate bolts that go into the front cross member? The front skid,tranny skid,and t-case skid bolts are M10x1.50,the gas tank skid/hitch bolts are M12x1.25.
|
|
| Author: | JeepinMaxx [ Sat May 10, 2008 12:39 am ] |
| Post subject: | Re: Skid plate bolt size? |
tjkj2002 wrote: the gas tank skid/hitch bolts are M12x1.25.
I think the gas tank skid / hitch bolts are M12x1.75 I spent $20  on a M12x1.75 tap to chase the threads when I installed the Rusty's gas tank skid and rear hitch. Everything seemed to bolt up right after that. I hope I had the right thread pitch
|
|
| Author: | tjkj2002 [ Sat May 10, 2008 7:52 am ] |
| Post subject: | Re: Skid plate bolt size? |
JeepinMaxx wrote: tjkj2002 wrote: the gas tank skid/hitch bolts are M12x1.25. I think the gas tank skid / hitch bolts are M12x1.75 I spent $20 on a M12x1.75 tap to chase the threads when I installed the Rusty's gas tank skid and rear hitch. Everything seemed to bolt up right after that. I hope I had the right thread pitch |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|