and why is everyone pounding them?
| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| stupid question....what are pinch welds http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=3&t=37918 |
Page 1 of 1 |
| Author: | BjBnet [ Thu Dec 04, 2008 12:54 am ] |
| Post subject: | stupid question....what are pinch welds |
and why is everyone pounding them?
|
|
| Author: | jsc7002 [ Thu Dec 04, 2008 1:00 am ] |
| Post subject: | |
pound them for more room to fit bigger tires, I dont think I can explain it vvery well but Im sure someone has a pics of it that will help you more |
|
| Author: | mrkake [ Thu Dec 04, 2008 1:01 am ] |
| Post subject: | |
Pinch welds are found on unibody vehicles. In other words, our Libertys do not have a frame that is separate from the body. The pinch welds are where two component pieces are welded together. They pound them down because the protrude into the wheel well and when you run bigger tires they will rub on that protrusion. Hope that helps! |
|
| Author: | Inc [ Thu Dec 04, 2008 1:27 am ] |
| Post subject: | |
Look behind your front tires. there will be a 1" wide protruding piece in the fender that is the pinch weld. The piece starts at the bottom of the wheel well and runs up about 6 or 7 inches. |
|
| Author: | jeepkj02 [ Thu Dec 04, 2008 10:07 am ] |
| Post subject: | |
Good how-to on pounding your pinch welds. HOW-TO: POUNDING THE PINCH WELD |
|
| Author: | nosnorb_808 [ Fri Dec 05, 2008 9:30 am ] |
| Post subject: | |
The only stupid question is the one not asked. I've asked this same question myself. Everyone on this forum is very helpful sometimes in a sarcastic manner though 
|
|
| Author: | Jeep Dawg [ Fri Dec 05, 2008 9:37 am ] |
| Post subject: | |
The pinch welds are in the way. We beat them because they are in a stupid spot and they anoy the crap out of us when we try to slapp on bigger boots |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|